Skip to main content

Illuminated road studs aid roundabout safety

In a bid to improve safety at the Sheriffhall roundabout near Edinburgh, Scotland, Clearview Traffic has been working with BEAR Scotland on an innovative accident reduction project at the complex six-arm gyratory roundabout which is used by over 42,000 vehicles per day. The project, which Clearview says is the first of its kind in the UK, uses the company’s IRS2 intelligent hardwired road stud to increase driver awareness and improve lane discipline on and off the roundabout. Improvements and efficien
July 15, 2014 Read time: 2 mins
In a bid to improve safety at the Sheriffhall roundabout near Edinburgh, Scotland, 557 Clearview Traffic has been working with BEAR Scotland on an innovative accident reduction project at the complex six-arm gyratory roundabout which is used by over 42,000 vehicles per day.

The project, which Clearview says is the first of its kind in the UK, uses the company’s IRS2 intelligent hardwired road stud to increase driver awareness and improve lane discipline on and off the roundabout.

Improvements and efficiencies made to the traffic signal-controlled roundabout in recent years have dramatically increased its capacity. BEAR Scotland was keen to ensure safety measures were improved in line with the increased use of the roundabout. Investigations found that inadvertent lane drifting was a significant contributory factor to negotiating it safely.

To address this issue, whilst at the same time causing minimal impact on the existing road markings and supporting infrastructure of the roundabout, BEAR Scotland and Clearview Traffic devised a unique road stud layout scheme that would guide the A720 traffic from either direction safely around and off the roundabout.

With the new system in place, as soon as the traffic signal on the entrance to the roundabout turns green, studs embedded in the road surface immediately illuminate and guide drivers onto the appropriate lanes of the roundabout. As the traffic signal turns red, all the studs on that section switch off and the studs on the next section illuminate as the corresponding traffic signal turns green. In this way, drivers now get an illuminated green phase to guide them all the way around and off the roundabout, with clear visual definition of the lanes to heighten lane discipline and reduce preventable collisions.

For more information on companies in this article

Related Content

  • New research: to illuminate or not to illuminate
    February 5, 2013
    Researchers from the US Lighting Research Center (LRC) and Penn State University have recently published a paper entitled “To illuminate or not to illuminate: Roadway lighting as it affects traffic safety at intersections”. Published in the journal Accident Analysis and Prevention the paper describes a parallel approach to lighting safety analysis. Tackling the tricky questions of when and where to install roadway illumination, while at the same reducing municipal costs, is a challenge for transportation a
  • Aimsun assesses Spain V2X impact
    June 21, 2022
    An Aimsun project with C-Roads Spain to assess the impact of Day 1 V2X services has been completed: Aimsun senior transportation modeller Laura Torres explains some of the results
  • WiM avoids bumps in the road
    May 5, 2020
    Road surfaces are deteriorating as years of budget squeezes bite among local authorities. Adam Hill asks leading Weigh in Motion players what effect this might be having on the accuracy of their technology – and how authorities can be made to see that WiM is a helpful tool
  • Transmax trials emergency vehicle ‘green wave’
    December 6, 2013
    Existing equipment used in Australian emergency vehicle ‘green wave’ trial. Despite the lights and sirens, accidents between the motoring public and emergency vehicles on their way to/from the scene of an incident are relatively frequent. Figures from various sources indicate that road accidents are the second most frequent cause of death for on-duty fire fighter fatalities and that more than 90% of ambulance and fire engine accidents occur when the lights are on and the sirens wailing. Other studies indica