Skip to main content

Georgia gets SCOOT

Siemens has won a new SCOOT (Split Cycle Offset Optimisation Technique) project in the US State of Georgia, in an area to the north of Atlanta along State Route 9. In the first phase, SCOOT will control thirty-three intersections in the towns of Alpharetta, Roswell and Sandy Springs and it is expected that more intersections will be added to the system over the next few years. The project is being managed by Siemens USA with local dealer Temple.
May 9, 2013 Read time: 2 mins
189 Siemens has won a new SCOOT (Split Cycle Offset Optimisation Technique) project in the US State of Georgia, in an area to the north of Atlanta along State Route 9. In the first phase, SCOOT will control thirty-three intersections in the towns of Alpharetta, Roswell and Sandy Springs and it is expected that more intersections will be added to the system over the next few years.

The project is being managed by 121 Siemens USA with local dealer 580 Temple.

Following testing of a demonstration system by 754 Georgia Department of Transportation which highlighted the benefits of adaptive control and after comparison with a leading system, it was determined that SCOOT would be an excellent long term solution.

Further analysis by 831 Federal Highway Administration (FHWA), concluded that, of SCOOT’s many desirable features, the one of particular importance was the ability to run the system with ordinary traffic plans but to also have the capability to invoke SCOOT when desired.  

It was determined that with the Siemens configuration, the clients could continue to run standard traffic patterns using the Siemens TACTICS traffic management system.  However, when requested, the SCOOT system can activate a full adaptive system which can be turned on and off by the SCOOT system scheduler.

Roadside implementation has already begun and the full SCOOT implementation is expected to be completed by the end of the summer.

A tender has also been released to expand the system with an additional thirty-four intersections before the initial deployment has been completed.  The initial deployment will be for 33 intersections.

Related Content

  • Mobinet counters weighty cross border concerns
    November 9, 2017
    A Mobinet pilot is combining onboard weighing with V2X comms to streamline vehicle weight enforcement. David Crawford reports. Pan-European, cross-border weigh-in-motion (WIM) for trucks is now a practical possibility, following successful Scandinavian trials within the EU-co-funded Mobinet (Internet of Mobility) programme. New technology is using strain sensors, located on load-bearing components and routinely installed in truck fleet management systems.
  • In vehicle systems allow drivers to provide travel information
    July 27, 2012
    The use of a Vehicle Data Translator will allow every vehicle on a given segment of road to contribute to a highly accurate, readily accessible source of localised weather information, thus improving safety in all conditions. Sheldon Drobot and William P. Mahoney III, US National Center for Atmospheric Research, Paul A. Pisano, USDOT/Federal Highway Administration, and Benjamin B. McKeever, USDOT/Research and Innovative Technology Administration, write. On the morning of June 10 2009, under the cover of den
  • Delivering accurate bus information
    July 27, 2012
    John C. Toone, King County Metro, describes the transition to an IntelliDrive-led approach to communication and information sharing in line with the introduction of a new bus rapid transit service. King County Metro (KC Metro), which serves Seattle, Bellevue and over 20 suburban towns, has been active in the development of intelligent transportation systems for many years. It has operated a signpost-based AVL system for more than a decade and has used this to provide bus location information to the public o
  • When caring about sharing is good business for US automakers
    October 28, 2015
    Although car-sharing and ride-sharing could drastically reduce car sales, David Crawford finds some US automakers are keen to participate in the sharing economy. Growing consumer interest in car- and ride-sharing, as opposed to outright ownership, and ride-sharer Uber’s recently stated intention to make its brand competitive with ownership on cost, are making the major US automotive manufacturers think seriously about their future sales prospects. Some have already begun exploring ways of entering the field