Skip to main content

Dubai RTA signs BeemCar ‘sky pod’ deal

Dubai’s Roads and Transport Authority (RTA) has its sights set on higher things than cars.
By Adam Hill March 6, 2020 Read time: 2 mins
RTA has its sights set on higher things than cars

The organisation has signed a deal with UK firm BeemCar to accelerate the installation of futuristic ‘sky pod’ transit in the city, which would see commuters being transported in pods on a network of cross-beams over the heads of pedestrians and drivers.

The pods are described by the manufacturer as a cross between a monorail and a ski-lift.

Dubai’s Self-Driving Transport Strategy aims to divert 25% of total mobility journeys in Dubai to autonomous transit by 2030 – and RTA believes putting commuters into the air could also help congestion.

The four-seater pods are suspended from a drive unit that sits inside a hollow beam, mounted on low friction wheels that go along tracks inside the beam at 50 km/h (30mph), at half second intervals, propelled by linear induction motors.

BeemCar says these beams are arranged in a criss-cross network above a city with a clearance height of 5m below the pods – and can transport more than 20,000 commuters per hour.
 
RTA says that the operation of such units occupies land area several times less than conventional means of the same capacity. 

Director general Mattar Mohammed Al Tayer explained: “The move corresponds to RTA’s efforts to enhance the integration of mass transit modes, and offer a solution to the first- and last-mile challenge which helps riders reach their final destinations.”

Passengers get on board the pods at ground-level stops - like bus stops – which are 500-800m apart.

“Once aboard, the door closes and the pod is accelerated from ground level back onto the main beam, where it slots into a gap between other pods all travelling on the beam in the same direction,” BeemCar explains.

“The pod will travel direct to its programmed destination where it will turn off the main beam and decelerate into the stop, dropping back down to ground level,” the manufacturer’s website says. 

“This is achievable as the pod has only a single hinged point of suspension and will remain horizontal irrespective of the gradient of the beam, which can be in excess of 60%, much like a chair lift."
 

For more information on companies in this article

Related Content

  • On a WIM – a global view of weigh in motion
    May 25, 2016
    Q-Free’s Andrew Lees looks at regional characteristics and technology trends in the global Weigh-In-Motion market. The principles of Weigh-In-Motion (WIM) are well established. Data derived from vehicles passing over in-ground sensors can be interpreted for vehicle classification (axle counts and spacing) and positive identification (especially when linked to image capture) applications as well as to derive individual axle and gross vehicle weight (GVW).
  • #ITSDubai2024: Driving the future of mobility through ITS
    August 30, 2024
    The ITS World Congress 2024, set to take place in Dubai from September 16-20, promises to be a landmark event for the global ITS community. Here is an in-depth look at what visitors can expect from their time at the cutting edge of mobility technology...
  • Accurate vehicle detection with Radix wired sensors
    February 8, 2016
    Radix Traffic will be featuring at Intertraffic Amsterdam its wired magnetometer sensors, over 500 of which have been installed in the UK to provide accurate vehicle detection. Unlike conventional inductive loops, the sensors can be installed around 50cm below the road surface where they are protected from damage caused by bad weather and heavy traffic. Radix claims that once a sensor is installed it will continue to detect during its 15-year design life with no maintenance required. Radix says installat
  • Radix Traffic features wired magnetometer sensors
    April 5, 2016
    Radix Traffic will be featuring at Intertraffic its wired magnetometer sensors, over 500 of which have been installed in the UK to provide accurate vehicle detection. Unlike conventional inductive loops, the sensors can be installed around 50cm below the road surface where they are protected from damage caused by bad weather and heavy traffic. Radix claims that once a sensor is installed it will continue to detect during its 15-year design life with no maintenance required.