Skip to main content

Design improvements for better truck safety delayed till 2022

On 10 March, the European Parliament approved amendments to the directive on the maximum authorised dimensions and weights for trucks and buses. The final agreement allows for much needed design adaptations to make cabs safer, but only following a revision by the European Commission of the cab type-approval. This means that manufacturers will not be required to implement these changes until 2022. It further retains each Member State’s right to decide whether or not they want to allow the use of mega trucks
March 11, 2015 Read time: 3 mins
On 10 March, the European Parliament approved amendments to the directive on the maximum authorised dimensions and weights for trucks and buses. The final agreement allows for much needed design adaptations to make cabs safer, but only following a revision by the 1690 European Commission of the cab type-approval.

This means that manufacturers will not be required to implement these changes until 2022. It further retains each Member State’s right to decide whether or not they want to allow the use of mega trucks cross-border.

FIA Region I welcomes the revisions of the directive that will make trucks safer and respects Member States’ rights. However, it is clear that vested interests have managed to delay implementation of the new cab design through the extended period for revision of the current type-approval. This decision may also delay the Commission’s target of halving road deaths in Europe by 2020.

FIA Region I director general, Jacob Bangsgaard said: “The goal of this directive was safer trucks on European roads and the FIA is pleased that it has, finally, been approved. But the timeline given to the Commission will delay necessary changes that should be implemented right away for better efficiency and safety. We know that truck drivers currently suffer from a lack of visibility that can cause grievous harm to vulnerable road users. This is why, in this case, the final timeline lets down road users and does not serve the cab drivers either. We had hoped to see a more disciplined time frame to implement these design improvements that would allow those manufacturers who are ready now to make safer and more fuel efficient cab designs the opportunity to do so for the benefit of all.”

Amendments to this directive were necessary to improve road safety and there must be for further action to improve vehicle safety and environmental standards, including the mandating of driver assistance systems to protect vulnerable road users. On the issue of mega trucks, Member States should be encouraged to carry out impact assessments before allowing the use of longer trucks on national roads.

To raise awareness of vulnerable road users, such as bikes, scooters and motorcycles, the FIA is launching a pan-European ‘Think Bikes’ campaign with a special focus on the visibility inside the cab of a truck. The event will take place on 21 April at Place du Luxembourg in front of the European Parliament from 12:00 to 14:00 with the participation of Belgian cycling star, Eddy Merckx; Belgian motorsport champion Jacky Ickx; MEP, Wim van de Camp; and FIA Region I president, Thierry Willemarck. At the event, there will be the chance to experience the limited visibility of a truck driver by sitting in the cab of a commercial vehicle, provided by the IRU. There will also be a demonstration of innovative bike lighting technology to alert drivers to the presence of cyclists by the company Blaze, and the chance to pick up stickers that can be added to a car’s side mirrors to remind drivers to keep an eye out for cyclists. Participation in this open air event is open to all, in hopes to raise awareness among all road users to "Think Bikes"!

For more information on companies in this article

Related Content

  • Driverless truck could improve workzone safety
    August 27, 2015
    A driverless truck, demonstrated this week by Pennsylvania vehicle manufacturer Royal Truck and Equipment, could help improve workzone safety, says the company. The truck, fitted with special rear-end crash attenuators and lights, was demonstrated using GPS waypoints and following a lead car, mimicking its path, braking and speed. The company has teamed up with Micro Systems to integrate military technology into truck mounted attenuators (TMA), which are used on many roads in the US to protect workers
  • New York Citi Bike pilots laser safety light
    January 16, 2017
    As part of an ongoing commitment to safer cycling in New York, the Citi Bike program is installing a new safety feature, the Blaze Laserlight, on 250 bikes this winter, with the aim of making Citi Bike riders more visible to drivers and pedestrians. The light uses laser technology to project a bike symbol six metres in front of the rider and, unlike the standard beam of bike lights, is visible from various perspectives. According to Citi Bike, research on use of the Laserlight on London’s bike share f
  • ITS industry needs more effort to get to the future
    January 19, 2012
    Eric Sampson, visiting professor at Newcastle University and City University London and ambassador for ITS-UK, provides a retrospective on the last couple of decades and takes a look at what the ITS industry still needs to do to get to where it needs to be
  • Enforcement suppliers highlight industry best practice
    March 15, 2012
    Major suppliers of enforcement technology highlight the countries, regions or cities that they consider to be leading the way in reduction of road traffic violations. The French government’s ambitious programme of enforcing traffic law violations has proven to be an unrivalled success and is continuing to bring improvements in road safety with innovative enforcement technology.