Skip to main content

Design improvements for better truck safety delayed till 2022

On 10 March, the European Parliament approved amendments to the directive on the maximum authorised dimensions and weights for trucks and buses. The final agreement allows for much needed design adaptations to make cabs safer, but only following a revision by the European Commission of the cab type-approval. This means that manufacturers will not be required to implement these changes until 2022. It further retains each Member State’s right to decide whether or not they want to allow the use of mega trucks
March 11, 2015 Read time: 3 mins
On 10 March, the European Parliament approved amendments to the directive on the maximum authorised dimensions and weights for trucks and buses. The final agreement allows for much needed design adaptations to make cabs safer, but only following a revision by the 1690 European Commission of the cab type-approval.

This means that manufacturers will not be required to implement these changes until 2022. It further retains each Member State’s right to decide whether or not they want to allow the use of mega trucks cross-border.

FIA Region I welcomes the revisions of the directive that will make trucks safer and respects Member States’ rights. However, it is clear that vested interests have managed to delay implementation of the new cab design through the extended period for revision of the current type-approval. This decision may also delay the Commission’s target of halving road deaths in Europe by 2020.

FIA Region I director general, Jacob Bangsgaard said: “The goal of this directive was safer trucks on European roads and the FIA is pleased that it has, finally, been approved. But the timeline given to the Commission will delay necessary changes that should be implemented right away for better efficiency and safety. We know that truck drivers currently suffer from a lack of visibility that can cause grievous harm to vulnerable road users. This is why, in this case, the final timeline lets down road users and does not serve the cab drivers either. We had hoped to see a more disciplined time frame to implement these design improvements that would allow those manufacturers who are ready now to make safer and more fuel efficient cab designs the opportunity to do so for the benefit of all.”

Amendments to this directive were necessary to improve road safety and there must be for further action to improve vehicle safety and environmental standards, including the mandating of driver assistance systems to protect vulnerable road users. On the issue of mega trucks, Member States should be encouraged to carry out impact assessments before allowing the use of longer trucks on national roads.

To raise awareness of vulnerable road users, such as bikes, scooters and motorcycles, the FIA is launching a pan-European ‘Think Bikes’ campaign with a special focus on the visibility inside the cab of a truck. The event will take place on 21 April at Place du Luxembourg in front of the European Parliament from 12:00 to 14:00 with the participation of Belgian cycling star, Eddy Merckx; Belgian motorsport champion Jacky Ickx; MEP, Wim van de Camp; and FIA Region I president, Thierry Willemarck. At the event, there will be the chance to experience the limited visibility of a truck driver by sitting in the cab of a commercial vehicle, provided by the IRU. There will also be a demonstration of innovative bike lighting technology to alert drivers to the presence of cyclists by the company Blaze, and the chance to pick up stickers that can be added to a car’s side mirrors to remind drivers to keep an eye out for cyclists. Participation in this open air event is open to all, in hopes to raise awareness among all road users to "Think Bikes"!

For more information on companies in this article

Related Content

  • ITS Australia: cooperative ITS closer to reality
    March 7, 2014
    ITS Australia welcomes recent Australian policy and international standards announcements that pave the way to making connected vehicles a reality and expanding opportunities for Australian innovation. Another important international step toward wireless connectivity for vehicles was the 12 February announcement of technical standards by the European Telecoms Standards Institute (ETSI) and the European Committee for Standardisation (CEN). These standards ensure that vehicles made by different European ma
  • Variable message signs continue to deliver travel information
    February 2, 2012
    Arguably the 'face' of ITS, variable message signs are far from being a passing solution
  • Making eCall Happen workshop
    February 22, 2016
    The I_Hero project has organised a workshop to address the challenges and opportunities that need to be met to ensure successful introduction of eCall in the different EU Member States. It will also offer insights into how commercial companies can leverage maximum benefit from this introduction. The workshop takes place at Le Chatelain Boutique Hotel, Brussels on 26 April from 0900-1700. eCall will be mandated in Europe for all new types of cars and light trucks manufactured after 31 March 2018. Membe
  • Hillsborough County signs up Causeway One.network
    June 20, 2024
    Communications solution designed to improve safety for workers and drivers in Florida