BlipTrack deployed for travel time measurement in Danish city

The Danish city of Aarhus, which has the second-largest urban area in Denmark after Copenhagen, has chosen BlipTrack to measure travel time and traffic flow following eight months of thorough testing of the system. The results showed that Blip Systems’ small and non-intrusive Bluetooth solution could offer the same exact information as alternative and more expensive solutions.
August 10, 2012 Read time: 1 min
The Danish city of Aarhus, which has the second-largest urban area in Denmark after Copenhagen, has chosen BlipTrack to measure travel time and traffic flow following eight months of thorough testing of the system. The results showed that 3778 Blip Systems’ small and non-intrusive Bluetooth solution could offer the same exact information as alternative and more expensive solutions.

So far, 60 BlipTrack sensors have been installed with the main purpose to measure travel time; inform and warn about queues and delays; identify problem areas; evaluate and calibrate traffic signals; improve capacity on existing roads; and detect changes in traffic patterns.
Urban Traffic Control

For more information on companies in this article

Related Content

  • Transport and technology innovation from South Australia
    September 7, 2016
    The Adelaide-headquartered Department for Planning, Transport and Infrastructure has partnered with Sydac and Sage Automation to showcase South Australian transport and technology innovation at the ITS World Congress Melbourne. Visitors to the stand (2213) will be able to try rail and bus training simulators, as well as check out Addinsight, a freeway and arterial road incident detection and congestion management system.
    Read More
  • System predicts train delays and informs response
    February 25, 2016
    David Crawford looks into the near-term future for Stockholm’s rail commuters. Swedish rail operator Stockholmståg, which runs commuter services in and around the country’s capital, is claiming a world first with the introduction of its automated Pendelprognosen (commuter prognosis) service. Developed to enable the prediction of delays as much as two hours before they are likely to occur, this offers the operator the scope for much earlier remedial action than previously - for example by filling in the expe
    Read More
  • Transition to all electronic tolling leads to cost savings
    February 2, 2012
    How a temporary congestion-relief solution resulted in the North Texas Tollway Authority's transition to all-electronic toll collection and potential savings of up to $472 million by 2045. By Carla Kienast, ETC Corporation
    Read More
  • US state of the art workzone safety
    January 25, 2012
    The Texas Transportation Institute's Jerry Ullman talks about the state of the art in work zone safety in the US. Work zones are places where, perhaps more than anywhere else on the road network, mobility and safety are strongly linked. Historically, field crews and contractors wanted vehicles in work zones to be moving as slowly as possible, assuming that made conditions the safest for work crews. We are though starting to see a shift in such thinking with the realisation that excessive delays or slow-down
    Read More

Highlighted Content