Solar power highlights Sernis' new road studs

SR-i19 and SR-i25 developed for road delineation, including bends and crosswalks
By Adam Hill June 2, 2023 Read time: 1 min
SR-i19 solar stud: visible up to 1km away

Sernis has launched two solar road studs: SR-i19 and SR-i25.

They use microcontroller technology, and only rise 9mm and 10mm respectively from the road surface: the company says they are "ideal for road delineation, bends/curves, and crosswalks among other applications".

They have constant brightness during all functioning periods and can be seen up to 1km away.

SR-i19 has a high light output due to its 3 LEDs for each side, with an aluminum base giving it strong mechanical resistance.

SR-i25 has a stainless-steel cap that makes it ready for snowploughs, while built-in GPS technology allows flashing synchronisation. It is also available in aluminum.

Sernis highlights its high-performance photovoltaic solar module, with silicone-free junction sealing technology allowing better, faster, and cleaner maintenance.

The technology applied to both models "increases the performance of solar power studs with energy storage by battery or capacitors and protects the road stud against the deep discharge of the batteries/capacitors", Sernis insists. 

'Sleep' mode prevents discharge during storage or transport, and the manufacturer points to their ease of installation and the fact that the studs require "virtually no maintenance".

Urban Traffic Control Air Quality & Weather Systems

For more information on companies in this article

Related Content

  • Masks and AI: the new mobility reality
    June 26, 2020
    French authorities are using artificial intelligence to track face covering compliance
    Read More
  • The challenges of start-stop technology
    September 9, 2013
    According to automotive technology supplier Dayco, the number of vehicles featuring start-stop technology will continue to rise over the next few years. The company says that it is only by incorporating such a function into a number of models in each range, that vehicle manufacturers will be able to reduce their fleet average emission levels and achieve the targets that EU legislation demands. Dayco, in alliance with Peugeot/Citroën, has developed a starter/alternator that has an auxiliary belt system w
    Read More
  • Mounting benefits of dynamic tolling project
    January 30, 2012
    Wisconsin's four-year HOT lanes pilot project, launched in May 2008, cost US$18.8 million to construct. Halfway into the project, which uses variably priced, or dynamic, tolling to improve highway efficiency, the benefits are mounting. The problem was obvious, and frustrating, to anyone who ever sat in bumper-to-bumper traffic on State Route 167 and watched a lone car whiz by every 20 seconds or so in the carpool lane. But for planners at the Washington State Department of Transportation, the conundrum was
    Read More
  • Continental developing road departure protection systems
    June 25, 2015
    International automotive supplier Continental is working on new road departure protection systems that aim to eliminate unintended road departures, which currently are not completely covered by today’s lateral guidance advanced driver assistance systems (ADAS), preventing fatal accidents from occurring on highways and rural roads. According to the US Department of Transportation Federal Highway Administration, approximately 55 per cent of traffic fatalities in the US involve a vehicle crossing the roadwa
    Read More

Highlighted Content