Skip to main content

Adaptive control reduces travel time, cuts congestion

Situated in San Diego County, California, the growing city of San Marcos has seen its population increase by 53.5 per cent since the turn of the century. Although this dramatic population increase has spurred economic growth bringing new business, homes and opportunities to the city, it has also increased traffic congestion along its central corridor, San Marcos Boulevard. This became the most congested arterial in the city, and, by 2006, the second-most travelled corridor in San Diego County.
January 20, 2012 Read time: 4 mins

Situated in San Diego County, California, the growing city of 798 San Marcos has seen its population increase by 53.5 per cent since the turn of the century. Although this dramatic population increase has spurred economic growth bringing new business, homes and opportunities to the city, it has also increased traffic congestion along its central corridor, San Marcos Boulevard. This became the most congested arterial in the city, and, by 2006, the second-most travelled corridor in San Diego County.

The corridor, though less than 6km long, accommodates as many as 46,000 motorists per day and is home to two schools and a multitude of businesses. The fourlane corridor has 17 major and minor intersections, including a couple of signals at freeway ramps.


The largest challenge for this corridor is three peak travel periods during the day; morning, midday and evening.

To help combat the growing traffic congestion, city traffic engineers were tasked with finding a way to improve traffic flow. The ideal solution would use ITS technologies, rather than expanding the existing four-lane roadway to the six lanes necessary to accommodate such large daily traffic volumes. From this, the 'Smart Corridor' project was born.

Project:

Reduce traffic congestion on busy arterial

Project Costs: US$671,000

Benefits:

• First-year savings: $645,000
• Lifetime savings: $5.1 million
• Delay time reduction: Up to 46 per cent
• Cost benefit ratio: 8:1

Vast improvement

"The idea behind the Smart Corridor project was to find a technology that would truly optimise the boulevard," says Omar Dayani, principal civil engineer for the City of San Marcos. "We needed to enhance traffic flow with a solution that would provide the maximum benefit to the public at a minimal cost to the city. A report by the 831 Federal Highway Administration (FHWA) showed that adaptive traffic signal control technology yielded, on average, a 10 per cent improvement in performance metrics including travel time, delay, stops, emissions and fuel consumption. 10 per cent sounded like a vast improvement to us, but we were striving for more.

After much research and consideration, my team and I chose to employ an adaptive control system, QuicTrac by 772 McCain, to maximise our results."

Deployment

The San Marcos Boulevard project was primarily funded by the Traffic Light Synchronization Program (TLSP) with a 15 per cent local match. The deployment went through two stages of optimisation.

First, the city used historical traffic flow data to better coordinate signal timing along the corridor. After the initial stage was successfully installed and working, the city's consulting firm laid the groundwork for phase two: adaptive control software. The adaptive software took the coordinated signal timing a step further by capturing and using realtime traffic conditions to optimise timing along the corridor. The system went through several rounds of testing and tweaks before it was fully operational.

"Every highly travelled arterial has its challenges different from the next, so it is imperative to choose a software partner that will work with your city's specific conditions," says Jason Stack, principal for Stack Traffic Consulting.

System results

Following the implementation of adaptive software, the city conducted a data analysis to determine the success of the project. Results showed significant improvements in delay times and corridor speed. The findings indicated that commuters driving the corridor experienced results as high as a 46 per cent and 39.1 per cent reduction in delay time and stops, respectively. Averaged over the three peak periods, and considering travel in both directions, the system yielded 19.5 per cent fewer stops, a 5.8 per cent speed increase, and a 7.1 per cent reduction in fuel consumption.

"Results for the adaptive software system met our expectations," states Omar. "The study indicated a 46 per cent reduction in delay time in the eastbound direction (the peak direction) during the evening peak period. That means less stop-and-go traffic yielding reduced travel times, emissions and probability of accidents. However, there was no significant improvement in westbound direction during this period." The City of San Marcos undertook a financial analysis which concluded total savings of $645,000 in the first year and $5.1 million over the lifetime of the project, with a benefit:cost ratio of 8:1. The calculations included cost benefits of travel time savings, fuel consumption savings, and reduced emissions of reactive organic gases, nitrogen oxides, particulate matter (PM10s), and carbon dioxide. An additional cost, not calculated in this report, is the health impact that congestion plays on city residents, recently quantified in The Public Health Costs of Traffic Congestion Study by Harvard University. The study shows that traffic congestion-related gas emissions caused approximately 3,000 premature deaths in 2005 with a total social cost of $24 billion in healthcare-related expenses. The bottom line is that by employing adaptive signal control software, the city of San Marcos effectively reduced traffic congestion, saving the community time, money, and healthcare-related expenses.

For more information on companies in this article

Related Content

  • Reducing detection costs benefits intersection management
    February 3, 2012
    The continuing, favourable performance-versus-cost situation concerning detection and monitoring technologies is driving the proliferation of intelligence across road networks. The effective and safe management of intersections is a focus for network operators and systems manufacturers alike. The most complicated of road environments, and statistically among the least safe, intersections enjoy particular emphasis in longer-term work on cooperative infrastructure solutions. However there are current developm
  • Australian road pricing, road funding needs more debate
    January 31, 2012
    Everyone in the road transport industry in Australia is talking road pricing - everyone, that is, except the politicians. Christine Keyes reports. At the end of 2008, Australia's road transport industry was wringing its collective hands, unable to raise more than $100 million from an individual bank for any Public Private Partnership (PPP). The A$750 million Peninsula Link project, announced by the Victoria Government in March 2009, was the first road project in the country to be put out to market as an ava
  • Columbia goes intermodal to support sustainability
    April 10, 2014
    David Crawford on the ups and downs of a Latin metropolis. Medellín, Colombia’s second city and a recognised leader in sustainable transport thinking, is rapidly extending its substantial existing investment in modern mobility. It is deploying both an enhanced integrated traffic management array and the country’s first intermodal public transportation management system. The supplier of both, under separate €9 million (US$12.3 million) contracts, is Spanish engineering company Indra, a major exporter
  • Fleet tracking system delivers cost and customer benefits
    May 22, 2012
    Introduction of a fleet tracking system has provided expected headline benefits. But it is the intangibles that have been most valuable Crescent Electric Supply Company (CESC) was founded in 1919 and is one of the largest independent distributors of electrical hardware and supplies in the US. Based in East Dubuque, Illinois, the company has 120 distribution facilities in 27 states, serving contractors, original equipment manufacturers (OEM) and the maintenance, repair and operations (MRO) needs of commercia