Skip to main content

Wireless charging project could change perceptions of electric vehicles

A two-year pilot project has begun in London with taxi firm Addison Lee and electric vehicle (EV) manufacturer Renault, which uses the principle of magnetic induction to jump electricity from a base station direct to the vehicle’s battery to deliver wireless charging. The charging technology being used is called Halo and has been developed by mobile innovations company Qualcomm, the organisation responsible for processors powering the latest generation of smartphones and tablets. ‘EV drivers will opt for th
October 10, 2012 Read time: 3 mins
A two-year pilot project has begun in London with taxi firm 6687 Addison Lee and electric vehicle (EV) manufacturer 2453 Renault, which uses the principle of magnetic induction to jump electricity from a base station direct to the vehicle’s battery to deliver wireless charging.

The charging technology being used is called Halo and has been developed by mobile innovations company 213 Qualcomm, the organisation responsible for processors powering the latest generation of smartphones and tablets. ‘EV drivers will opt for the simplicity of wireless charging because there’s no fuss from dirty cables that are difficult to handle in the cold and wet,’ says a Qualcomm spokesman.

Halo consists of a black pad, about the size and thickness of a newspaper, positioned centrally in a parking bay and either laid flat on the tarmac or buried slightly beneath it. The electricity running through the pad creates a virtual bubble above it and as long as the receiver unit on the car is inside that perimeter, the battery will automatically power up.

As the car approaches a Halo-enabled parking bay, it establishes a Bluetooth connection with the control unit and an alignment display switches from red to green to; after a few seconds, the screen changes to confirm power is going into the battery.

The system is currently configured to accept a domestic power supply, so it takes eight hours to charge a vehicle, although the development of a more advanced unit could reduce that time to around 90 minutes.

Using a standard EV, the Delta E4, designed and built by 6688 Delta Motorsport, that has been modified to use the wireless system, impressive results have apparently been obtained: when the battery is fully charged, it has a 140 mile range, reaches 60mph in around 6.5 seconds and has a top speed in excess of 100mph.

The Delta E4’s interior has a centrally mounted touch-screen interface, slightly smaller than an iPad, which controls everything from the audio to the air conditioning and also oversees the charging procedure.

Renault, which is supplying cars for the trial, has invested hugely in electric vehicles and is aiming to be the first mass-market manufacturer to offer a completely zero-emission model range.  Jacques Hebrard, Renault’s advanced projects director, says, “Our participation complements our European research project to demonstrate wireless induction charging of electric vehicles in a public environment with a high level of performance and safety.”

For more information on companies in this article

Related Content

  • SESA supports MassDOT travel time network
    April 6, 2016
    SES America (SESA) has designed, engineered and manufactured over three hundred solar-powered embedded dynamic message signs (DMS) to be installed as part of the Massachusetts Department of Transportation’s (MassDOT)‘Go Time’ project. According to SESA, once completed, the project will provide the largest travel time network available in any state in the US, allowing motorists across the country to instantly access travel time data on major corridors across the region. Each site consists of static sig
  • Liberty Charge creates EV boost
    May 22, 2020
    Under-the-pavement power comes to the fore
  • Timing is everything for EV charging
    January 23, 2020
    Electric vehicles are often promoted as a more sustainable alternative to diesel and petrol cars - but their arrival raises concerns about the strain which charging will put on the grid.
  • Electric park brake technology gaining momentum in North America
    April 19, 2012
    TRW, a specialist in active and passive safety, says it has been awarded new business for its next-generation electric park brake (EPB) technology with two major North American based vehicle manufacturers. The system functions as a conventional hydraulic brake for standard service brake applications, and as an electric brake for parking and emergency braking. TRW launched the first integrated caliper EPB system in 2001 and is bringing the wide range of functional and ancillary benefits of EPB to the North A