Vital Technology data comms network deployed at Dublin Port Tunnel

Vital Technology has supplied a data communications network system to Egis Road & Tunnel Operation Ireland (ERTO) for the Dublin Port Tunnel which opened to traffic in 2007 and is the longest urban tunnel in Europe as well as the largest civil engineering project ever undertaken in Ireland. While core components are proving durable, communication systems became subject to early obsolescence and were causing networking problems and unscheduled closures which prompted the upgrade.
July 13, 2012 Read time: 3 mins
6028 Vital Technology Ltd has supplied a data communications network system to Egis Road & Tunnel Operation Ireland (ERTO) for the Dublin Port Tunnel which opened to traffic in 2007 and is the longest urban tunnel in Europe as well as the largest civil engineering project ever undertaken in Ireland. While core components are proving durable, communication systems became subject to early obsolescence and were causing networking problems and unscheduled closures which prompted the upgrade.

Vital Technology has delivered a scalable, resilient, fault-tolerant system with dual redundancy across data networking and SCADA subsystems. The network uses 1028 Cisco components and manages a broad range of subsystems including CCTV surveillance from 311 Bosch whose analogue cameras are attached to blade encoders. The CCTV operates on a ‘one-to-many’ multicasting basis whereby the video is sent to a core switch whose artificial intelligence decides where to forward the stream.

Other principal subsystems in use at the Dublin Port Tunnel include public address & voice alarm (PA/VA) which is benefiting from a proprietary protocol by audio specialists Peavey.  This solution digitises messages over exceptional relay distances of up to 4.5km before the information is converted into analogue data at the core and put through a standard PA unit.

As Vincent Byrne, control systems manager at ERTO, explains, “The sensing technology in any major road tunnel is extensive, with equipment detecting carbon monoxide, carbon dioxide and nitric oxide. At this site, all these detection units are wired back to remote, dedicated industrial PCs which control the I/O. These remote units are located approximately one kilometre apart, each dealing with up to 300 pieces of input and output, and integrated into the Vital network.

“The Vital and ERTO engineers had to segregate the network both horizontally and vertically. There were VLANs whose behaviour was dependent on what equipment type was being used. Add to this the Layer 3 switching and the unusual demand of multicasting CCTV, and it will be seen that the complexity of the project was successively compounded. This was done to ensure that a failure of a single device would never impact upon tunnel availability and safety. Vital’s response to the brief was impressive and the solution has proved successful in the field,” Byrne said.

Crucially, Vital managed to reuse existing fibre optic cabling and in a manner that made the network more resilient by creating a redundant ring topology. Another challenge was overcoming persistent problems with the legacy IP-addressing scheme.
Networking & Communication Systems

For more information on companies in this article

Related Content

  • Siemens to equip Turkey’s suspension bridge with traffic control technology
    September 28, 2012
    Siemens is to supply the traffic control system for the world’s fourth longest suspension bridge, to be built between Istanbul and Izmir in Turkey. Siemens will be responsible for the development, installation and commissioning of all components and systems for the traffic control technology, including the traffic control system, monitoring technology and components for the technical infrastructure such as communication and camera equipment, energy supply, lighting and ventilation. Siemens will also supply
    Read More
  • UK town to use traffic lights to tackle speeding
    April 25, 2012
    Swindon in the UK is set to trial smart traffic lights which turn to red if approaching drivers are breaking the speed limit. Sensors will detect speeding vehicles and if they are above a preset limit then the signals ahead will turn to red. If congestion builds up then the traffic light phasing will change automatically to allow more traffic through the junction. ANPR systems will detect emergency vehicles and ensure they are not inhibited by the system.
    Read More
  • LiDAR sets its sights on future problems
    February 23, 2017
    AAdvances in LiDAR are helping transport authorities improve services and identify potential problem areas, as geospatial technology expert Dr Neil Slatcher explains. The effects of climate change on the transport infrastructure have long been a cause of concern within the transportation sector - and not only on the structures themselves but also on the surrounding areas. This year, those concerns have become reality with landslides, structural collapses and surfacing issues impacting services across the wo
    Read More
  • Study looks at air quality impacts of low carbon buses
    December 11, 2013
    A new report prepared by Ricardo for the Low Carbon Vehicle Partnership (LowCVP) to review the air quality impacts arising from the recent rapid increase in the number of low carbon buses in the UK recommends that the legislation needs to consider hybrid technology impacts in the test processes to avoid potential unintended consequences in terms of local emissions. As they mainly operate in urban areas, local emissions from buses are of particular significance. Reviewing worldwide test processes for
    Read More

Highlighted Content