Four firms selected to provide equipment for Connected Vehicle Safety Pilot Program

Kapsch, ITRI International, Cohda Wireless and Cisco Systems, and Savari Networks have been selected by the Intelligent Transportation Systems Joint Programme Office (ITS JPO) to provide roadside equipment as part of the Connected Vehicle Safety Pilot Programme. The contracts were awarded by the Federal Highway Administration (FHWA) which solicited quotations from suppliers to provide all the necessary equipment, materials, and services for the development and production of the devices. Each of the device
April 23, 2012 Read time: 2 mins
RSS81 Kapsch, ITRI International, Cohda Wireless and 1028 Cisco Systems, and Savari Networks have been selected by the Intelligent Transportation Systems Joint Programme Office (781 ITS JPO) to provide roadside equipment as part of the Connected Vehicle Safety Pilot Programme. The contracts were awarded by the 831 Federal Highway Administration (FHWA) which solicited quotations from suppliers to provide all the necessary equipment, materials, and services for the development and production of the devices. Each of the devices selected by FHWA will be used to send messages such as signal phase and timing, curve speeds etc to vehicles using Dedicated Short Range Communications (DSRC).

The roadside devices are part of the US DOT’s Connected Vehicle Safety Pilot Program, a major research initiative that will test how ordinary drivers in real world driving conditions will respond to wireless safety messages. The drivers will be using vehicles that communicate with each other and will communicate with surrounding infrastructure such as traffic signals and work zones.

The Connected Vehicle Safety Pilot program will start in August 2011 and run though the first half of 2013.  There are two components to the programme, Safety Pilot Driver Acceptance Clinics and Safety Pilot Model Deployment. Devices that were awarded contracts will be put on a qualified products list and only those devices can be used in the model deployment. There will be no roadside equipment in the Driver acceptance clinics.
Networking & Communication Systems

For more information on companies in this article

Related Content

  • Smart transport systems investment will continue to grow despite public sector cuts
    May 30, 2012
    The ITS sector is now going through an evolution driven by the maturation of communications technologies and their increasing adoption in major cities worldwide. The widespread availability of high-speed networks, both fixed and wireless, along with the ability to embed intelligence in physical objects throughout the urban environment and the diffusion of mobile devices that can send and receive real-time vehicle or infrastructure information, is driving the adoption of smart transportation systems in citie
    Read More
  • Mobinet counters weighty cross border concerns
    November 9, 2017
    A Mobinet pilot is combining onboard weighing with V2X comms to streamline vehicle weight enforcement. David Crawford reports. Pan-European, cross-border weigh-in-motion (WIM) for trucks is now a practical possibility, following successful Scandinavian trials within the EU-co-funded Mobinet (Internet of Mobility) programme. New technology is using strain sensors, located on load-bearing components and routinely installed in truck fleet management systems.
    Read More
  • Radar effective as detection tool for hard shoulder running
    July 23, 2012
    Navtech Radar's millimetric-wave systems are being researched on the M42 in England to look into how this type of detector can assist in the opening of the hard shoulder as an additional running lane. Here, the company's Stephen Clark talks about the technology being used. In England, the Highways Agency's (the HA, an executive agency of the Department for Transport) Managed Motorways system - formerly called Active Traffic Management - uses electronic signs and signals mounted on gantries to direct drivers
    Read More
  • Belarus ETC system starts operations
    August 1, 2013
    The country-wide electronic toll collection (ETC) system is Belarus has begun operations, replacing the manual tolling system on 815 kilometres of the country’s road network. The US$353 million contract was awarded to Kapsch TraffiCom in 2012. The system, based on Dedicated Short Range Communication (DSRC) technology, comprises 56 tolling and enforcement gantries and 48 customer service points, together with two modern data centres were implemented, 500,000 on board units for automatic payment and sixteen
    Read More

Highlighted Content