Skip to main content

Berlin introduces wirelessly-charged electric bus Line

Berlin has become the first capital city to introduce a wirelessly charged electric bus, as part of a project funded by Federal Ministry of Transport and Digital Infrastructure. The Berlin Transport Authority, Berliner Verkehrsbetriebe (BVG) has introduced four Solaris Urbino 12 electric buses equipped with the Bombardier Primove inductive charging system and traction equipment from Vossloh Kiepe. The buses now operate on the 6.1 kilometre line 204 between Südkreuz and Zoologischer Garten (Hertzallee). Vos
September 4, 2015 Read time: 2 mins

Berlin has become the first capital city to introduce a wirelessly charged electric bus, as part of a project funded by Federal Ministry of Transport and Digital Infrastructure.
The Berlin Transport Authority, Berliner Verkehrsbetriebe (7580 BVG) has introduced four Solaris Urbino 12 electric buses equipped with the Bombardier Primove inductive charging system and traction equipment from Vossloh Kiepe.

The buses now operate on the 6.1 kilometre line 204 between Südkreuz and Zoologischer Garten (Hertzallee). Vossloh Kiepe’s electric drive ensures the vehicles are not only emission-free, but also produce low vibration and noise, benefitting both passengers and the environment.

Each bus will be charged wirelessly and contactlessly via 513 Bombardier’s inductive Primove technology which enables the buses to recharge in just a few minutes.

Bombardier claims that the Primove battery system, with a total capacity of 90 kilowatt hours, offers sufficient energy reserves to handle even Berlin’s most demanding routes. In addition, the wireless charging system is well shielded so that the electromagnetic radiation is lower than that of a conventional induction cooker. To fully charge the batteries overnight and air condition the passenger compartment before starting operation, four stationary and one mobile charging station were also installed by Vossloh Kiepe at the BVG depot. There the buses are supplied with power via charging cables.

Like all BVG’s electric powered vehicles, the new Solaris Urbino 12 electric buses are powered exclusively with green electricity. BVG says that within one year, the four electric buses on the line 204 will travel a total of approximately 200,000 kilometres, saving 260 tons of CO2 emissions.

For more information on companies in this article

Related Content

  • Toshiba develops electric-powered bus with short charging time
    May 1, 2012
    Small buses owned by Tokyo's Minato Ward, in Japan, will be retrofitted by with new motors and lithium-ion cells developed by electronics major Toshiba. In fiscal 2013, the Ward aims to start full operations of the electric-powered buses and conduct pilot runs by end-fiscal 2012. The Ward intends to deploy the buses for short journeys in housing locations, as the buses need to be recharged after a trip about 12km in a bid to maintain the battery level higher than 50 per cent. At this level of battery status
  • Sensys provides traffic detection tech in Berlin 
    August 12, 2020
    FlexRadar sensor in-ground sensor is immune to electromagnetic interference, firm says
  • Electric bus fleet for Sao Paulo, Brazil
    October 9, 2012
    Mayor of the City of Sao Paulo in Brazil, Gilberto Kassab has announced plans for electric buses from Chinese manufacturer BYD to run in the city by the end of the year. There are approximately 15,000 public buses in the city of Sao Paulo today; however fleet buses are responsible for more than 20% of total transportation emissions. BYD says its electric bus is not only zero-emissions but also economical. It is estimated that energy savings of US$246,000 could be saved during the life cycle of a San Paulo
  • Victorian government to implement high capacity signalling on new rail line
    July 18, 2017
    The Victorian government, Australia has awarded CPB Contractors and Bombardier Transportation the contract to deliver the US$790 million (AU$1 billion) Rail Systems Alliance in Melbourne, which includes the roll-out of a 55 kilometre long high capacity signalling (HCS) and communications system. HCS allows trains to safely run closer together, meaning they can run more often. The technology will enable trains every two to three minutes, creating a ‘turn-up-and-go’ train network for Melbourne. The signalling