Combining Bluetooth and wi-fi to optimise traffic signals

Optimisation of traffic signals is often seen as a challenging and expensive task, requiring inductive loops, cameras or manual counting for traffic monitoring. However, a new development from Danish wireless technology company Blip Systems aims to change that. BlipTrack uses a combination of Bluetooth and wi-fi to constantly monitor and map traffic flow. The system detects all vehicles containing Bluetooth or wi-fi enabled devices to provide accurate traffic data, enabling real-time traffic monitoring a
May 8, 2013 Read time: 1 min
Optimisation of traffic signals is often seen as a challenging and expensive task, requiring inductive loops, cameras or manual counting for traffic monitoring.  
However, a new development from Danish wireless technology company 3778 Blip Systems aims to change that.  

BlipTrack uses a combination of Bluetooth and wi-fi to constantly monitor and map traffic flow.  The system detects all vehicles containing Bluetooth or wi-fi enabled devices to provide accurate traffic data, enabling real-time traffic monitoring and allowing operators to make adjustments to traffic signal timing, optimising traffic flow and reducing travel time.  Drivers can also receive real-time information on incidents and congestion.

BlipTrack sensors are independent of light and weather conditions, require no maintenance and can be installed without disrupting traffic. The system can cover broad road networks with sensors installed at key points, providing a cost effective traffic management solution.
Networking & Communication Systems Urban Traffic Control

For more information on companies in this article

Related Content

  • Progressing work zone safety systems
    February 1, 2012
    David Crawford investigates progress in a key safety area - work zones. Highway construction zone safety is taken seriously enough in the US to merit a special spring National Work Zone Awareness Week, which in 2010 ran from 19-23 April. Headed by the US Department of Transportation's Federal Highway Administration (FHWA), this aims to reduce an annual toll of work zone deaths - 720 in 2008 (an average of one every 10 hours) with more than 40,000 traffic injuries (an average of one every 13 minutes).
    Read More
  • Progressing work zone safety systems
    February 6, 2012
    David Crawford investigates progress in a key safety area - work zones
    Read More
  • Bluetooth technology to shorten travel times
    April 20, 2016
    A new traffic app recently launched in Adelaide, South Australia, is helping drivers avoid roadworks and traffic jams with real-time updates. AddInsight taps into more than 400 of Adelaide’s state-of-the-art Bluetooth receivers, which monitor the city’s road network in real-time and broadcasts verbal messages to drivers in about approaching delays through a vehicle’s hands free systems and mobile phones. The free app has been released at a time when the South Australian capital’s road network has been
    Read More
  • 3M reflect on why CAVs need lines and signs
    May 10, 2017
    Tammy Meehan and Thomas Hedblom of 3M consider the ongoing development of technology needed to introduce connected and autonomous vehicles. The transportation industry is in the midst of the most dramatic shift since Henry Ford introduced horseless carriages. Already we are seeing the increased use of advanced driver assistance systems (ADAS) which, along with the introduction of autonomous vehicles in the next few decades, will bring profound changes to vehicles and the environment in which they operate.
    Read More

Highlighted Content