 
     Cheaper and easier communications are providing authorities with new options for influencing driver behaviour.  Colin Sowman reports.     
     
It’s official; Average speed cameras (ASCs) cut the number of fatal or serious injury crashes by more than a third. That is the finding of a survey by the independent 
     
The survey, undertaken for the RAC Foundation by 
     
All of the fully analysed sites were fitted with camera systems from 
     
Perhaps the most significant outcome of recent installations is that average speed cameras change drivers behaviour in a way that spot speed cameras have never managed. Once spot speed cameras were erected, local drivers (and those with satellite navigation) either learned or were notified of the location of the cameras so many slowed to the posted speed as they approached the camera sites only to speed up again once out of range. 
 
Not only did these drivers continue to exceed the posted speed limit between cameras, but harsh braking as they approached a camera location was, itself, the cause of a number of crashes as well as congestion. In some instances, this behaviour caused an overall rise in crashes and was seized upon by the anti-speed camera campaigners.
With ASCs, this behaviour is reversed because both local drivers and  those with sateliite navigation systems know a road has average speed  enforcement meaning the majority stick to the speed limit, removing the  need for harsh braking when approaching a camera location.  
     
To  calculate the average speed, the exact location and distance between  two or more cameras is accurately measured. The time a vehicle takes to  travel between the two correlates to their average speed. The A9 in  Scotland is a good example. With 112 cameras on 56 distinctive yellow  columns spaced along 220km (137 miles) of often remote highway between  Dunblane and Inverness, it is Europe’s longest average speed enforcement  zone. While the scheme is included in the RAC’s wider analysis, changes  to truck speed limits at the time the ASCs were installed, exclude it  from being one of the 25 sites used in the final safety-gain statistics.
     
Instead  of needing hard-wiring between the pairs of cameras and from the  cameras to the control centre, mobile communications technology is used  to relay data back to the control room, this leaves the operators the  freedom to decide which cameras are active and in which configuration.    
     
“Each camera is  programmed with its sequence number and uses 3G or 4G communications  along with GPS to pick up a location and time signal. Captured  information is quickly encoded and sent, along with the vehicle’s  registration details, back to a central server,” says Geoff Collins,  Jenoptik UK’s sales and marketing director.
     
Only  when the encrypted registration plates are matched and the time signals  are compared in the control centre does it become evident if an offence  has been committed. This is much faster and easier to achieve than  visiting rural sites to download the information – or even collect film  for processing. Where an offence has been committed an ‘evidence pack’  containing encrypted details of the vehicle and offence(s) can be  instantly transmitted to the police. Plate details and images that are  of no interest are soon deleted and overwritten, so motorists’ movements  are not routinely logged.  
     
One  of the biggest benefits of ASCs is that they change driver behaviour.  The old trick of speeding between spot speed sites and braking sharply  when approaching a camera location no longer works. In the RAC report  the distance between paired cameras ranged from 390m to 46km (28.5  miles) and with ASCs drivers do not know which cameras are active and  what configuration is being used. 
 
Short  of stopping altogether, a driver who has exceeded the speed limit  for  any distance will not be able to reduce their average speed in the  last  300m of the section-end camera. This brings about the favourable  changes  in driver behaviour that spot speed failed to deliver, with  most  drivers travelling smoothly throughout the monitored zone. 
     
This   is evident from the mid-point figures from the A9 Safety Group which   show that the proportion of vehicles exceeding the speed limit is now 1   in 10 compared to the benchmark of 1 in 3. Furthermore, the proportion   of vehicles being driven at more than 16km/h (10mph) above the speed   limit has reduced dramatic from 1 in 10 to 1 in 250. Overall traffic   volumes have increased by 6% since the cameras were installed, yet only   an average of 13 drivers per day are considered for further action by   the police and, most importantly, the number of fatalities has dropped   by one-third.
     
This is   fulfilling the aims of the A9 Safety Group which states on its website:   We don’t want your money; we do want you to comply with the speed limit   and in doing so improve safety.
     
When   hard-wiring was the only option, instrumentation over such a distance   and terrain would have been unthinkable - but now all that is needed is  a  power supply. 
     
“That’s the beauty of combining average speed and mobile communications; you can position a camera almost anywhere. 
     
Instead   of needing to run power and communications cables to the camera, you   can position the camera where the power is available and use mobile   phone technology and GPS to do the rest,” says Collins.
 
“With   spot speed you have to position the camera at the location where  the   speeding is a problem; with average speed you can place the  cameras   either side of the blackspot wherever there is a convenient  power   supply. Communications technology will take care of the rest  and, as a   result, motorists are more likely observe the posted speed  limits over a   much longer section of road, instead of charging towards  the camera   before braking rapidly.”
     
And    as the power consumption of electronic systems reduces all the time,   in  many parts of the world these installations could be  battery-powered   stand-alone units with solar recharging.
     
Average    speed enforcement systems use ANPR in order to identify vehicles,   using  integral infra-red illuminators to image the plates when it is   dark.  However, in order to capture overview or context images in the   hours of  darkness, additional infra-red flood lights allow for good   scene images  to be captured, even when the road appears to be   completely dark.  This  is a particular benefit for the A9 in the   Cairngorms National Park. This  has ‘dark skies’ status, and in such   areas a visible flash or dazzling  pool of white light could prove a   major distraction for drivers. 
     
Mobile    communications also make the measuring of average speed across a    network of roads, or even a town, much easier regardless of the number    of entry and exit points. Hard-wiring a host of individual cameras  would   be highly disruptive and prohibitively expensive but with mobile    communications that cost is slashed to little more than the hardware    purchase. 
     
The terrain  and   ambient conditions can affect mobile communications so the system  has   to be designed to cope with temporary losses of connection. On the  A9   which rises to 350m (1,159ft) above sea level as it skirts the  Cairngorm   Mountains, the cameras have a data storage facility to hold  the   encrypted information in the event of a communications outage  which can   then transmit it when the connection is restored. Any  long-term failure   of communications is highlighted in the control  room. And, as all   cameras use the same GPS time signal, the time taken  to drive between   two points can be directly calculated from the  timestamps and is not   dependent on when that data arrived at the  control room.
     
For    authorities looking to replace ageing spot-speed cameras, serious    consideration must be given to moving to an average speed system that    could bring about changes in driver behaviour over a much wider    geographical area.
Signal to signals
         
Following a fatal crash close to a signalised junction on the A78 in the Scottish village of Fairlie, traffic surveys identified that drivers regularly exceeded the 50km/h (30mph) speed limit. 
         
 
         
The system uses wireless magnetometer vehicle sensors positioned in both lanes at between 136m and 144m from the stop line in order to detect the speed of approaching vehicles.
         
This information is relayed to speed-activated warning signs and the traffic signals. When a speeding driver is detected, the traffic lights are programmed to turn red in order to stop speeding vehicles and increase the journey time to beyond that realised at the posted speed. 
         
The partners worked on the complex operational configurations to ensure that triggering the traffic lights to turn red did not create a danger to road users or pedestrians.
         
So instead of installing speed enforcement and penalising errant drivers, the scheme aims to influence their behaviour positively.    
     
 
 
     
         
         
        



