Skip to main content

C/AVs could mean cheaper roads

The safety benefits of C/AVs have long been promoted – but research suggests they should also contribute to cheaper roads. David Crawford investigates the potential benefits in infrastructure costs Building narrower freeway lanes to accommodate the enhanced route-tracking capabilities of connected and autonomous vehicles (C/AVs), running in platoon conditions, could result in cost savings of £0.5 million (€0.56 million or US$6.5 million) for every km of road length built. Such benefits could be secur
October 28, 2019 Read time: 6 mins
Building narrower freeway lanes for C/AVs, running in platoons, could result in cost savings, experts suggest © Kittiphat Abhiratvorakul | Dreamstime.com
The safety benefits of C/AVs have long been promoted – but research suggests they should also contribute to cheaper roads. David Crawford investigates the potential benefits in infrastructure costs


Building narrower freeway lanes to accommodate the enhanced route-tracking capabilities of connected and autonomous vehicles

(C/AVs), running in platoon conditions, could result in cost savings of £0.5 million (€0.56 million or US$6.5 million) for every km of road length built. Such benefits could be secured without any serious loss in the level of service available to road users as a whole.

These are among the key findings of a new study by the UK University of Southampton’s Transportation Research Group (TRG), reported at the July 2019 annual conference in Leeds of the Universities’ Transport Study Group (UTSG). It finds the current national highway cross-section standard ‘too conservative’ - particularly in terms of lane widths, which have to include an allowance for the lateral inaccuracies inherent in human-controlled driving.

There would also be important gains in safety, fuel economy and reduced CO2 emissions, according to lead researcher Hameed Jehanfo, a qualified civil engineer. Earlier studies in the field of C/AV highway provision have been based on existing design standards, or on roads built without taking into account vehicles’ close route- tracking capabilities.

The challenge was to fill this gap, by developing a specification for a new type of lane that would deliver worthwhile economies. To pave the way for this, Jehanfo took the example of a standard, 16.48m long, 2.55m wide European articulated truck as presenting “the most onerous vehicle space demands”. He then used data from wheel odometry-based 3D Lidar, inertial measurements and a GPS-based locating unit to identify the additional space allowance that would be needed to cope with the minor tracking deviations that such a vehicle would inevitably make.


Increased margin

The results showed the need for a margin of 10cm on either side of it, a figure then rounded up to generate an overall 2.80m width requirement for outer (nearside) dedicated C/AV lanes running alongside inner ones still conforming to the 3.65m standard (which already includes an allowance for the lateral inaccuracies of human-controlled driving).  

The search for a real-life illustrative case study of the cost implications identified a 22km section of the planned Lower Thames Crossing, east of London, a freeway-standard link due to open in 2027 to relieve increasing pressure on an existing upstream river crossing. Earlier feasibility studies had identified the impracticability of widening this to accommodate a growing traffic load, much of it international.

The designated route of the new crossing includes provision for a number of horizontal and vertical lane centreline alignments, weaving sections, cuttings, embankments and bridges – all of these features adequately representative of the physical characteristics of typical existing freeways. This made it ideal, Jehanfo told ITS International, to support the central aim of the study in demonstrating the beneficial cost impacts of an alternative, “less onerous” geometric design. National road operator 8101 Highways England (HE) had already expressed a strong interest in future- proofing the crossing for C/AVs from the outset.

To derive the hoped-for economies, the study then applied standard construction-industry bills of quantities techniques to calculate the materials, plant, labour and time-cost elements of contracts for building out both the standard and the C/AV-friendly versions. It used detailed engineering design drawings that HE had produced for use in a 2018 public consultation. The results appear in Table 1 (see opposite page).

 

Achieving savings

Further investigation has also made it possible to derive the prospects of achieving a 122 tonne savings in CO2 emissions over 10 years, with beneficial implications for the greenhouse gas issue. The European Union (EU) has formally identified C/AV use as a key element in governmental efforts to slow the rate of climate change, stressing its beneficial effects in delivering higher transport system efficiency.

As the Southampton research reports, US studies of platoons in which HGVs are running at short headways have shown important reductions in aerodynamic drag, a major contributor to fuel consumption, leading eventually to decreased emissions. Another beneficial effect is that platoon convoy speeds vary much less than those of normal traffic, by enabling vehicles moving at 1.4 second time gaps to move at optimal engine and fuel consumption speeds. On safety, the study goes on to identify the scope for accident savings worth £10.8 million over 10 years on the same 22km stretch of road (see Table 2, below).

At the same time, it warns of the need for more work to establish the extent to which the widespread introduction of C/AVs could introduce new safety risks. Junction design, for example, with the need to manage merging/diverging and C/AV and manual traffic flows, needs to be studied in detail. There are also plans for additional engineering work involving visibility assessments and road restraint requirements to determine the extent to which these are influenced by reduced human input.

Another issue concerns the impact, on the forecast gains, of the costs of installing and operating the necessary supporting roadside infrastructure – an issue that the TRG is dealing with via a programme of expert interviews. Already in the planning stage is the development of a simulation model, using commercially available software, to enable the assessment of the impact of the proposed C/AV road design on varying traffic levels. The hoped-for result is a decision-supporting kit.

Primary mode in US?

A study of the passenger car C/AV sector, carried out in the US within Ohio University’s Future Of Driving programme, sees driverless vehicles becoming ‘the primary mode’ of personal transport in the country by 2050, and making huge inroads into the US$160bn annual cost of traffic congestion. But, chiming with the Southampton initiative, it warns that their ability safely to share roads with human-driven traffic will need greater flexibility than current highway designs are allowing for.

Benefits that it predicts include reductions in urban traffic pressures thanks to the vehicles’ ability ‘objectively’ to pick the best routes, using modern computing techniques and accurate and up-to-date traffic flow and incident data to gain commuters in metropolitan areas nearly an hour a day in productive time. In New York’s Manhattan central business district, it suggests that a pool of 9,000 driverless cars could replace the current 13,000-strong taxi fleet (at the expense, of course, of the ousted cab drivers’ livelihoods).

In the process, the waiting time for a cab - once summoned - would fall from the typical current average of five minutes to just over half a minute; while the cost of the subsequent journey would drop to €3.125 per km (US$5 per mile).  In terms of urban land take, an automated car would be able safely to manoeuvre in and out of parking bays that were 15% narrower than those of today. But the costs of acquiring such a vehicle, the university warns. will remain a deterrent while the current price of a Google-equipped car, if it were commercially available, would be around US$150,000.

Related Content

  • July 19, 2018
    Cost benefit: Toronto retimings tame traffic trauma
    Canada’s largest city reckons that it is saving its taxpayers’ money simply by altering the way traffic lights work. David Crawford reviews Toronto’s ambitious plans to ease congestion Toronto, Canada’s largest metropolis (and the fourth largest in North America), has saved its residents CAN$53 (US$42.4) for every CAN$1 (US$0.80) spent over a 2012-2016 traffic signal retiming programme, according to figures released by its Transportation Services Division. The programme covered 1,275 signals (the city’s
  • July 11, 2018
    Cost benefit: Toronto retimings tame traffic trauma
    Canada’s largest city reckons that it is saving its taxpayers’ money simply by altering the way traffic lights work. David Crawford reviews Toronto’s ambitious plans to ease congestion. Toronto, Canada’s largest metropolis (and the fourth largest in North America), has saved its residents CAN$53 (US$42.4) for every CAN$1 (US$0.80) spent over a 2012-2016 traffic signal retiming programme, according to figures released by its Transportation Services Division. The programme covered 1,275 signals (the city’s to
  • March 4, 2019
    Transport Systems Catapult boss: ‘We can’t build our way out of congestion’
    The UK Transport Systems Catapult’s CEO Paul Campion talks to Colin Sowman about helping companies develop tomorrow’s solutions – and explains why you can never build your way to empty roads The future of mobility is going to be driven by services.” That’s the opening position of Paul Campion, CEO of the Transport Systems Catapult (TSC) – the UK government organisation set up to help boost transport-related employment and the economy. Campion was previously with IBM and describes himself as a ‘techno o
  • July 8, 2019
    Cost benefit: Wichita eases workzone congestion
    Achieving higher diversion rates has helped one Kansas city to make traffic flow more efficient around workzones. David Crawford examines what’s behind a 10:1 benefit-to-cost ratio in Wichita Around 10% of highway congestion in the US results from delays in workzones, leading to an estimated annual loss of $700 million in fuel costs alone. The lack of accessible real-time traffic information to help motorists minimise their inconvenience – particularly at peak times - is a major contributor. One solut