Weigh in motion with high speed strip scales

Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.
December 18, 2014 Read time: 1 min
Intercomp strip scale

1982 Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.

They can be installed in one day in grooves less than 75mm (3inch) wide; minimising lane closures. The system weighs vehicles dynamically in the mainline axle-by-axle as they pass over the scales at speeds up to 129km/h (80mph).

The system includes two strip scales units, but can be configured with four or six strips per lane for higher sampling rates. They can be integrated into a user’s existing system with analog output, or coupled with Intercomp’s WIMLOGIX module which provides signal conditioning, data acquisition and basic processing.

Classification & Data Collection

For more information on companies in this article

Related Content

  • Dynamic lane closures cuts time, cost and congestion on Motorway roadworks
    March 17, 2014
    A combination of technologies is leading to major congestion and cost reductions during roadworks on the UK’s motorway network. Innovative construction programme scheduling technology and the deployment of moveable barriers has achieved substantial savings of money and time on UK motorway roadworks managed by the Highways Agency (HA). This combination has set the scene for a new generation of road usage analysis tools. The HA’s objective was to reduce the congestion caused by lane closures during roa
    Read More
  • Mobinet counters weighty cross border concerns
    November 9, 2017
    A Mobinet pilot is combining onboard weighing with V2X comms to streamline vehicle weight enforcement. David Crawford reports. Pan-European, cross-border weigh-in-motion (WIM) for trucks is now a practical possibility, following successful Scandinavian trials within the EU-co-funded Mobinet (Internet of Mobility) programme. New technology is using strain sensors, located on load-bearing components and routinely installed in truck fleet management systems.
    Read More
  • Cepton and Belam boost railway safety
    September 28, 2021
    Cepton says the system has achieved an accuracy of over 99.9% in obstacle detection
    Read More
  • WiM eases structural health worries
    February 12, 2024
    Concerns about infrastructure are leading road authorities to consider the importance of Weigh in Motion solutions to monitor the wellbeing of their roads – and particularly bridges – finds Adam Hill
    Read More

Highlighted Content