Weigh in motion with high speed strip scales

Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.
December 18, 2014 Read time: 1 min
Intercomp strip scale

1982 Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.

They can be installed in one day in grooves less than 75mm (3inch) wide; minimising lane closures. The system weighs vehicles dynamically in the mainline axle-by-axle as they pass over the scales at speeds up to 129km/h (80mph).

The system includes two strip scales units, but can be configured with four or six strips per lane for higher sampling rates. They can be integrated into a user’s existing system with analog output, or coupled with Intercomp’s WIMLOGIX module which provides signal conditioning, data acquisition and basic processing.

Classification & Data Collection

Related Content

  • May 24, 2016
    High-speed WIM moves onto the main highway
    High-speed weigh-in-motion is starting to make its mark on both sides of the Atlantic. As a transit country the Czech Republic experiences a large number of overloaded vehicles, which greatly increase highway maintenance costs. This prompted its Transport Ministry to trial an extension of the capabilities of the existing truck tolling system to allow the dynamic high-speed weighing of cargo vehicles. In effect the tolling enforcement gantries become weigh-in-motion (WIM) locations.
    Read More
  • June 3, 2025
    Intercomp's LS788-WIM portable scale gets NTEP certification
    System can send data to RFX-enabled indicators or PCs up to 90m away
    Read More
  • May 8, 2015
    IRD complements WIM with tyre under-inflation detection
    To complement its existing WIM offering, IRD has introduced a system to detect under-inflated and flat tyres at highway speeds. Tyre inflation pressure has both safety and economic impacts for road users and none more so than with commercial vehicles. An underinflated tyre has decreased directional control, increased risk of catastrophic failure, and negatively impacts tyre life and fuel economy. In June 2014 the USDOT published Large Truck and Bus Crash Facts 2012 in which the Federal Motor Carrier Safety
    Read More
  • May 7, 2021
    Change in the air for Brazil WiM
    Recent changes to weighing standards and legislation in Brazil allow for expansion of Weigh in Motion technology in an attempt to address some familiar challenges
    Read More

Highlighted Content