Weigh in motion with high speed strip scales

Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.
December 18, 2014 Read time: 1 min
Intercomp strip scale

1982 Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.

They can be installed in one day in grooves less than 75mm (3inch) wide; minimising lane closures. The system weighs vehicles dynamically in the mainline axle-by-axle as they pass over the scales at speeds up to 129km/h (80mph).

The system includes two strip scales units, but can be configured with four or six strips per lane for higher sampling rates. They can be integrated into a user’s existing system with analog output, or coupled with Intercomp’s WIMLOGIX module which provides signal conditioning, data acquisition and basic processing.

Classification & Data Collection

For more information on companies in this article

Related Content

  • C/AVs could mean cheaper roads
    October 28, 2019
    The safety benefits of C/AVs have long been promoted – but research suggests they should also contribute to cheaper roads. David Crawford investigates the potential benefits in infrastructure costs Building narrower freeway lanes to accommodate the enhanced route-tracking capabilities of connected and autonomous vehicles (C/AVs), running in platoon conditions, could result in cost savings of £0.5 million (€0.56 million or US$6.5 million) for every km of road length built. Such benefits could be secur
    Read More
  • TagMaster extends ANPR and RFID vehicle ident ranges
    April 6, 2016
    It is a two-pronged message from TagMaster with a new ANPR and RFID products.
    Read More
  • Xerox counts on machine vision for high occupancy enforcement
    October 29, 2014
    Machine vision techniques can provide solutions to some of the traffic planners most enduring problems With a high proportion of cars being occupied by the driver alone, one of the easiest, most environmentally friendly and cheapest methods of reducing congestion is to encourage more people to travel in each vehicle. So to persuade people to share rides, high occupancy lanes were devised to prioritise vehicles with (typically) three of more people on board and in some areas these vehicles are exempt from
    Read More
  • Consumer telematics driving automotive electronics
    February 3, 2012
    This year's Consumer Electronics Show in Las Vegas was characterised by consumer telematics solutions, writes Dave McNamara
    Read More

Highlighted Content