Weigh in motion with high speed strip scales

Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.
December 18, 2014 Read time: 1 min
Intercomp strip scale

1982 Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.

They can be installed in one day in grooves less than 75mm (3inch) wide; minimising lane closures. The system weighs vehicles dynamically in the mainline axle-by-axle as they pass over the scales at speeds up to 129km/h (80mph).

The system includes two strip scales units, but can be configured with four or six strips per lane for higher sampling rates. They can be integrated into a user’s existing system with analog output, or coupled with Intercomp’s WIMLOGIX module which provides signal conditioning, data acquisition and basic processing.

Classification & Data Collection

Related Content

  • March 21, 2018
    Haenni shows lightweight solution for low-speed WIM
    The WL400 is a new portable low-speed weigh-in-motion (WIM) wheel load strip sensor which is making its first appearance at Haenni’s stand in hall 10. Designed for pre-selection of vehicles, the 80mm wide sensor has an accuracy of ±2% (excluding external factors) at speeds of up to 20km/h and a capacity of 30tonnes per axle.
    Read More
  • February 28, 2019
    Intercomp launches LS-WiM system for fleet operators
    Intercomp has launched a low-speed Weigh in Motion (LS-WiM) system which it says allows fleet managers to collect the weight of vehicles without hampering traffic flow. The system is suitable for high-volume entry and exit gates and, unlike full-length truck scales, does not require incoming and outgoing traffic to stop every time a vehicle needs to be weighed, the company adds. According to Intercomp, the system’s small footprint allows it to be installed at most facilities at approximately half the co
    Read More
  • March 18, 2014
    Wider uses for weigh in motion data
    Colin Sowman talks to Terry Bergan of International Road Dynamics about the latest uses of weigh-in-motion systems. Raising allowable truck weight limits improve transport efficiency but leaves an ever-increasing number of bridges vulnerable to being overloaded and damaged by vehicles heavier, and in some cases far heavier, than they were designed to carry. The simplistic solution is to impose weight restrictions and erect appropriate signs - but this could have severe knock-on effect on trucking operations
    Read More
  • July 21, 2017
    Introducing the IRD SAW III portable dynamic scale system
    International Road Dynamics’ (IRD) durable IRD SAW III portable wheel load weigher is now available for dynamic weighing; its user-friendly software enables users to efficiently pre-select overloaded trucks. Two IRD SAW scales are paired and connected to a PC via Bluetooth. When a vehicle drives over the scales at slow speed, the weighing result, wheel/axle weights and gross vehicle weight, is displayed on the screen. For weight enforcement with the highest accuracy the system can be switched to static oper
    Read More

Highlighted Content