Kistler weighs in with its WIM systems

Swiss-headquartered Kistler is using ITS World Congress to present the company’s proven weigh-in-motion Lineas sensors, available in three sensor lengths: 15m, 1.75m and 2m, and two connecting cable length options – 40m and 100m.
October 29, 2019 Read time: 1 min
Joe Ong of Kistler

Direct from ITS World Congress 2019

Swiss-headquartered 657 Kistler is using ITS World Congress to present the company’s proven weigh-in-motion Lineas sensors, available in three sensor lengths: 15m, 1.75m and 2m, and two connecting cable length options – 40m and 100m.

In 2016, the Hungarian government adopted Kistler’s system, buying 1518 sensors to detect and identify overloaded vehicles in real time, says Joe Ong, general manager of Kistler Southeast Asia.

“We are able to provide proven WIM technology based on OIML R-134 certified system, as well as locally available technical support,” says Ong.


Supported by OIML certification, Kistler’s WIM systems are based on maintenance-free Lineas quartz WIM sensors and the Kistler WIM Data Logger.

Ong says the trend in the South East Asia’s largest ports is to upgrade entry and exit point weight check gates using targeted highly accurate no-stop WIM systems.

Classification & Data Collection

Related Content

  • You need to weigh up WIM systems thoroughly, says TDS
    September 16, 2021
    Traffic Data Systems (TDS) will use the ITS World Congress to focus on weigh-in-motion (WIM) systems for enforcement and tolling applications. But more than that, the company is addressing the issue of device certification - in cases where customers opt for the wrong / improper certification, WIM systems will not be legal for enforcement and tolling
    Read More
  • Traffic Data Systems receives Swiss certification for WIM system
    September 19, 2017
    Traffic Data Systems’ WIM-DSP 32 low-speed and high-speed weigh-in-motion (WIM) system has been awarded an OIML-R134-1 certificate by the Swiss Federal Institute of Metrology, proving accuracy levels of ±5% (initial verification) and ±10% (in-service inspection) have been achieved. The Swiss institute’s supervised certification process required more than 500 test runs with different vehicles, speeds and loads.
    Read More
  • On-road and in-vehicle are not in competition
    May 18, 2018
    The integrity and accuracy of data that can be verified by weigh-in-motion technology has been improving for decades – and the range of WIM applications is increasing at a tremendous pace. Chris Koniditsiotis, president of the International Society for Weigh-in-Motion (ISWIM) and CEO of Transport Certification Australia (TCA), began his career in 1985 as a pavements engineer. “When I joined this portfolio, the integrity, accuracy, and sampling frequency of mass information delivered at best an estimate, us
    Read More
  • TDS sets standard with launch of WIM-DSP 32
    April 5, 2016
    Germany-headquartered Traffic Data Systems (TDS) is here at Intertraffic to launch the TDS WIM-DSP 32. The company says it is the first Weigh-In-Motion system that has PSHC (Piezo Sensor Health Care) long-term sensor monitoring. According to TDS, it has set new standards in WIM with its PSHC and that TMCS-U, a complete TLS remote monitoring station, with WIM-DSP 32 can monitor up to eight WIM lanes with four Lineas sensors per lane. This complete eight lane weigh-in-motion system has an LED display that
    Read More

Highlighted Content