Skip to main content

Dual purpose for new weigh-in-motion site

A new weigh-in-motion weighbridge is being installed on State Highway 1 at the Rakaia Bridge to support the introduction of high productivity motor vehicles (HPMV) on this key South Island, New Zealand, freight route. The HPMV system allows vehicles carrying a divisible load of essential goods to weigh more than the official 44 metric tonnes without a permit, but only on specified routes.
October 13, 2014 Read time: 3 mins

A new weigh-in-motion weighbridge is being installed on State Highway 1 at the Rakaia Bridge to support the introduction of high productivity motor vehicles (HPMV) on this key South Island, New Zealand, freight route.

The HPMV system allows vehicles carrying a divisible load of essential goods to weigh more than the official 44 metric tonnes without a permit, but only on specified routes.

The NZ Transport Agency’s Southern regional director Jim Harland says as the Transport Agency works towards moving more freight on fewer vehicles throughout New Zealand, it is important to monitor the impact of heavier loads on roads and bridges to protect the assets from damage.

Two of the key assets on this critical transport link from Christchurch to Dunedin are the Rakaia and Rangitata No. 1 bridges, both of which were built in 1939 and are earmarked for US$8.3 million of strengthening work in the future.

“By installing the weigh-in-motion site we can monitor loads over the bridges to ensure we minimise any damage while we plan this work to achieve greater value from our assets,” said Harland.

He says monitoring to date had not identified any risks to the key assets from the operation of heavier freight vehicles on this route; however overloading had the potential to damage the assets.

“The US$392,000 weigh-in-motion site will also enable the Transport Agency to collect data for all vehicles travelling over the Rakaia Bridge and enable us to identify freight operators who are in breach of their permit. The site will have a camera for automated number plate recognition; we will follow-up with freight companies, whose trucks are overloaded, as well as checking on operational speeds and unpaid Road User Charges to assist with highway maintenance costs.”

It is expected the introduction of seven weigh-in-motion sites throughout New Zealand will assist with the recovery annually of US$2.3 million in unpaid road user charges.

He says the Transport Agency encourages willing compliance by freight operators because of the safety risk from overloading and disproportional wear and tear on the road network. “By operating a weigh-in-motion site we can collect the data and then target those operators who are in breach of their permit. This way we minimise the impact on the 90 per cent of truck drivers who comply with the regulations.”

A full compliance check can take 20 minutes to an hour, resulting in considerable lost time and added costs for freight operators.

Related Content

  • On-road and in-vehicle are not in competition
    May 18, 2018
    The integrity and accuracy of data that can be verified by weigh-in-motion technology has been improving for decades – and the range of WIM applications is increasing at a tremendous pace. Chris Koniditsiotis, president of the International Society for Weigh-in-Motion (ISWIM) and CEO of Transport Certification Australia (TCA), began his career in 1985 as a pavements engineer. “When I joined this portfolio, the integrity, accuracy, and sampling frequency of mass information delivered at best an estimate, us
  • Comprehensive communications combats tolling resistance
    May 19, 2017
    Toll road operator must provide clear, comprehensive and consistent communications to user groups and the local community long before the facility opens. When new tolled highway infrastructure is about to go into service, the construction, management and finance specialists who brought it into being are about ready for a well-deserved celebration. But for the communications and outreach team responsible for building public support for the project – for bringing drivers to the road, and keeping partners and
  • Milton Keynes to trial wirelessly charged electric buses
    September 26, 2012
    In an initiative to enable the quieter, cleaner future of public transport in Milton Keynes, UK, eight organisations led by a subsidiary of Mitsui Europe ("Mitsui") have agreed a five-year collaboration committing to the replacement of diesel buses with their all-electric counterparts on one of the main bus routes in the city by summer 2013. The trial, which could reduce bus running costs by between US$19,500 and US$23,000 per year, is a partnership between Mitsui subsidiary eFleet Integrated Service, Milto
  • Rosa Rountree calls for clarity and consistency
    December 16, 2015
    Rosa Rountree campaigns for accurate and consistent figures for the tendering of tolling concessions. If there is one thing about which Rosa Rountree is passionate, it’s numbers. That’s not surprising for a graduate accountant, but it is not only the quarterly accounts that concern the CEO and president of Egis Projects USA.