Teledyne Dalsa to expand Genie Nano camera range

Teledyne Dalsa is to launch three Genie Nano cameras equipped with Sony CMOS sensors which it says can be used for ITS and traffic applications. The Genie Nano 2.4M, M1950 and C1950 models offer a cost-efficient solution for organisations looking to upgrade vision inspection systems from Sony charge-coupled device (CCD) to CMOS imaging, the company adds. According to Teledyne, the M1950 and C1950 enable high-speed image capture without smear or distortion while the 2.4M is built around the Sony Pregi
April 16, 2019 Read time: 1 min
593 Teledyne Dalsa is to launch three Genie Nano cameras equipped with 576 Sony CMOS sensors which it says can be used for ITS and traffic applications.


The Genie Nano 2.4M, M1950 and C1950 models offer a cost-efficient solution for organisations looking to upgrade vision inspection systems from Sony charge-coupled device (CCD) to CMOS imaging, the company adds.

According to Teledyne, the M1950 and C1950 enable high-speed image capture without smear or distortion while the 2.4M is built around the Sony Pregius IMX392 ½” CMOS image sensors – the designated replacement for the ICX818 CCD sensors.

These Nano models are offered in 2.4 MP (1936 x 1216) resolution with a GigE Vision interface in either colour or monochrome.

Full production for the cameras is scheduled to begin in the second quarter of 2019.

Detection, Monitoring & Machine Vision

For more information on companies in this article

Related Content

  • Here: AI has place in ‘privacy by design’
    June 23, 2020
    Artificial intelligence may improve traffic in cities and keep location data private, but Here Technologies shows that it only takes four points of anonymous data to predict your identity.
    Read More
  • Parifex speed cameras: picture perfect
    September 30, 2020
    From speed cameras to smart cities, image processing and AI – Parifex is not short of ambition. Nathalie Deguen tells Adam Hill where the French company is heading next
    Read More
  • New technology is changing the Weigh In Motion landscape
    June 5, 2014
    Exciting new weigh in motion solutions were showcased at Intertraffic. Guy Woodford reports For many years weigh-in-motion (WIM) has been used solely as a filtering mechanism to detect potentially overloaded vehicles, but introductions at Intertraffic may see that change. At the Intertraffic exhibition to unveil its Apollo range of British-manufactured axle weighbridges was Applied Traffic. The in-motion and static axle-by-axle weighing system offers slow speed and portable weighing solutions suitable for
    Read More
  • IRD complements WIM with tyre under-inflation detection
    May 8, 2015
    To complement its existing WIM offering, IRD has introduced a system to detect under-inflated and flat tyres at highway speeds. Tyre inflation pressure has both safety and economic impacts for road users and none more so than with commercial vehicles. An underinflated tyre has decreased directional control, increased risk of catastrophic failure, and negatively impacts tyre life and fuel economy. In June 2014 the USDOT published Large Truck and Bus Crash Facts 2012 in which the Federal Motor Carrier Safety
    Read More

Highlighted Content