Skip to main content

Sony unveils polarised category for machine vision camera

Sony Europe’s Image Sensing Solutions (ISS) is showcasing its polarised category of machine vision camera at Traffic Vision in Stuttgart, Germany, 6-8 November. The company says the camera’s IMX250MZR sensor captures polarised light in four different angles. The XCG-CP510 GS CMOS camera simplifies stress inspection, contrast improvement, scratch detection, object detection, removal and enhancement from a single image capture, the company adds. The camera’s module is expected to deliver 5.1 MP polarised
October 17, 2018 Read time: 2 mins

4551 Sony Europe’s 5853 Image Sensing Solutions (ISS) is showcasing its polarised category of machine vision camera at Traffic Vision in Stuttgart, Germany, 6-8 November. The company says the camera’s IMX250MZR sensor captures polarised light in four different angles.

The XCG-CP510 GS CMOS camera simplifies stress inspection, contrast improvement, scratch detection, object detection, removal and enhancement from a single image capture, the company adds.

The camera’s module is expected to deliver 5.1 MP polarised B/W images at 23 fps, transmitted over a GigE interface

Sony’s camera includes multiple trigger modes such as edge detection, pulse width detection, bulk trigger, sequential trigger, free set sequence and a burst-trigger function. Also, the module can be fired via hardware or software triggers or via the IEEE1588 precision timing protocol, with the unit capable of acting as either a slave or dynamically assigned master device.

XCG-CP510 will be available in mass-production quantities from November and a polarised-camera software development kit will be available to speed and simplify the development of polarised-light applications for the hardware.

Related Content

  • October 18, 2018
    Basler to exhibit four Ace U cameras at Traffic Vision
    Basler will showcase four Ace U cameras which feature 20 MP resolution at Traffic Vision in Stuttgart, in Germany, 6-8 November. The company says a single camera can monitor multi-lane highways. The four ace U Models are suitable for inspection of structures such as printed circuit board or display production, the company adds. According to Basler, the U Models allow customers to use fewer cameras to achieve the same amount of pixels than before with cameras with lower resolution. This can also help
  • October 28, 2014
    Machine vision offers new solutions to old problems
    The transportation sector is set to benefit from a far wider range of machine vision technology. While machine vision techniques have been applied to traffic management applications for some years, in some areas there can still be a shortage of knowledge about what the technology can offer transportation professionals. The image processing and interpretation functions of machine vision enables control room staff to be immediately alerted to occurrences requiring attention which, in turn, enables each person
  • November 10, 2017
    Sony’s vision systems help limit risk in road tunnels
    Sony’s Stephane Clauss looks at the imaging requirements in tunnels. In the event of a fire inside a tunnel, the dispersion of gases and heat is prevented, creating extreme temperatures that have led to many deaths. Following tragic incidents including Mont Blanc, European legislation requires longer tunnels to be fitted with incident and smoke detection systems.
  • June 30, 2016
    IR’s invisible benefit for traffic surveillance and enforcement
    Advances in vision technology are enhancing traffic surveillance and enforcement applications. Variable lighting conditions have long been a stumbling block for vision technology applications in the transport sector. With applications such as ANPR, the read-rate may vary between daylight and night and can be adversely affected by glare and low sun. Madrid, Spain-based Lector Vision had these considerations in mind when designing its Traffic Eye ANPR system, which combines off-the-shelf and custom hardware