Skip to main content

New Mexico installs its first adaptive signal system

Work has begun on a US$343,000 project to install the first adaptive signal control system in Bernalillo County, New Mexico, to improve traffic flow along Alameda Boulevard, which has one of the highest traffic flows in the county. The system is a designated set of traffic signals that effectively communicate with each other and adapt to the traffic flow, reducing the frequency of red lights when traffic volume is high to improve overall traffic flow. County commissioner Lonnie Talbert said: “Up to 50,000 v
May 24, 2013 Read time: 2 mins
Work has begun on a US$343,000 project to install the first adaptive signal control system in Bernalillo County, New Mexico, to improve traffic flow along Alameda Boulevard, which has one of the highest traffic flows in the county.

The system is a designated set of traffic signals that effectively communicate with each other and adapt to the traffic flow, reducing the frequency of red lights when traffic volume is high to improve overall traffic flow.

County commissioner Lonnie Talbert said: “Up to 50,000 vehicles per day travel along Alameda.  This system will improve their overall travel time on a daily basis.”

The county will install video detection cameras and the program software for the adaptive signal control system at seven major intersections to collect real-time traffic flow information. The information will be used to optimise the signal timing based on real-time traffic conditions throughout the day. Peak hour traffic flow will be improved by adjusting the green times to improve overall traffic flow while not significantly increasing the wait times on the side streets.

The recent installation of thousands of feet of fibre-optic cable helped to establish the county’s own infrastructure for voice and data communications, which will allow the county to remotely operate and monitor the system from its traffic operations office.

The system is expected to be fully activated by the beginning of September.

Related Content

  • April 10, 2014
    Cellint measures speed and travel time without roadside infrastructure
    Collecting speed and travel time data without using roadside infrastructure could offer new possibilities to cash-strapped road authorities. Streaming video may be useful for traffic controllers to monitor incidents and automatic number plate recognition may be required for enforcement, but neither are necessary for many ITS functions. For instance travel times, tailbacks, percentage of vehicles turning, origin and destination analysis can all be done using Bluetooth and/or WI-Fi sensors and without video o
  • November 20, 2013
    Bluetooth and Wi-Fi offer new options for travel time measurements
    New trials show Bluetooth and Wi-Fi signals can be reliably used for measuring travel times and at a lower cost than an ANPR system, but which is the better proposition depends on many factors. Measuring travel times has traditionally relied automatic number plate (or licence plate) recognition (ANPR/ALPR) cameras capturing the progress of vehicles travelling along a pre-defined route. Such systems also have the benefit of being able to count passing traffic and have become a vital tool in dealing with c
  • March 28, 2022
    Lidar: recipes for success
    Lidar is being deployed all over the world - and you can even read a cookbook on the subject...
  • March 14, 2012
    Advanced ITS truck screening aids border control
    State-of-the-art ITS technologies are being deployed for tracking of commercial vehicles at the US-Mexico border in Arizona, reports Pete Goldin. The border between the US and Mexico may be the epitome of America's wild west, but this remote desert frontier is being tamed by the Arizona Department of Transportation (ADOT) with a state-of-the-art ITS system. A comprehensive port-of-entry (POE) screening system is being deployed at the Mariposa Port of Entry – one of the busiest land ports in the nation – at