Skip to main content

Smoothing intersection flow in the Netherlands

Flir's ThermiCam thermal sensors have been installed at a major signalised intersection with the Utrechtseweg (N237) and Wilhelminalaan in Utrecht in the Netherlands In a bid to smooth traffic flows while also taking account of the presence of cyclists. ThermiCam is an integrated thermal camera and detector for vehicle and cycle presence detection and counting at signalised intersections and provides an alternative to in-road loops. The sensor detects heat energy generated by cyclists and motorists and
December 9, 2014 Read time: 2 mins
6778 Flir's ThermiCam thermal sensors have been installed at a major signalised intersection with the Utrechtseweg (N237) and Wilhelminalaan in Utrecht in the Netherlands In a bid to smooth traffic flows while also taking account of the presence of cyclists.  

ThermiCam is an integrated thermal camera and detector for vehicle and cycle presence detection and counting at signalised intersections and provides an alternative to in-road loops. The sensor detects heat energy generated by cyclists and motorists and uses this to make a distinction between the two and transmits the information over contact closures or IP to the traffic signal controller to allow green times to be dynamically controlled based on the type of road user.

ThermiCam detects cyclists and vehicles in all light conditions, regardless of whether traffic is moving or stationary.  The sensor can also be used to count cyclists, even when they are riding in group.

“For this specific project, we needed a solution that was able to efficiently detect bicyclists and neglect motorists at the same time,” says Guus Sluijsmans, traffic engineer and account manager sales at 6999 Imtech Traffic & Infra, which installed the sensors. “The ThermiCam sensor from Flir Systems is the only solution I know that can efficiently make a distinction between bicyclists and motorists on the same traffic lane.”

For more information on companies in this article

Related Content

  • The benefits of Lidar
    March 21, 2022

    While Lidar is gaining ground in the ITS industry, it has not yet reached the level of mass adoption where it shows up frequently in requests for proposals (RFPs) from cities and DoTs.

  • GTT aids cyclist safety in Minneapolis
    July 14, 2016
    In a bid to improve conditions for cyclists in Minneapolis, Global Traffic Technologies (GTT) using existing infrastructure and its Canoga 9004 system to detect and react to bikes at intersections. The traffic detection system is now able to recognise both vehicle and bicycles and the Canoga card reacts quickly enough to give cyclists a green light without needing to slow down or wait at the intersection or navigate a red light. Previously, only vehicles would trigger green traffic signals at intersectio
  • Bridging the highway travel information gap
    March 14, 2012
    A new traffic management solution is attempting to bridge the gap in information available on freeways and arterial roadways. Andrew Bardin Williams reports. Agencies responsible for national networks of roads around the world have the ability to measure, analyse and disseminate accurate travel information to drivers. Millions of dollars go into data collection infrastructure to collect traffic congestion and travel time information on major freeways or highways. For example, a driver on the I-210 in the Lo
  • I-80 Smart Corridor sets the ITS standard for California's Bay Area
    March 23, 2015
    Colin Sowman looks at California’s ‘smartest’ road which will open this spring to counter congestion and accidents on one of the Bay Area’s busiest interstates. Interstate 80 (I-80) is one of the busiest roads in the San Francisco Bay area with up to 270,000 vehicles using the corridor every day. The section between the Carquinez Bridge in Crockett and the Bay Bridge not only suffers congestion during the working week but also at weekends. Traditional remedies such as building additional lanes (there are al