Skip to main content

NCDOT to install advance traffic warning system on I-277

The North Carolina Department of Transportation (NCDOT) is to install an advance warning system on the Interstate 277 (I-277) outer loop between Tryon Street and Interstate 77 in Charlotte, North Carolina. This system will detect traffic data such as volume and speed, alerting motorists to backups that frequently occur on the ramp from I-277 outer to I-77 north. The $188,000 project was awarded to Consolidated Power of Mooresville, who will install the detection warning system, consisting of two microwave
October 16, 2012 Read time: 2 mins
The 4775 North Carolina Department of Transportation (NCDOT) is to install an advance warning system on the Interstate 277 (I-277) outer loop between Tryon Street and Interstate 77 in Charlotte, North Carolina.

This system will detect traffic data such as volume and speed, alerting motorists to backups that frequently occur on the ramp from I-277 outer to I-77 north.

The $188,000 project was awarded to Consolidated Power of Mooresville, who will install the detection warning system, consisting of two microwave vehicle detection (MVD) units and two flashing LED beacons.  The MVD units will collect traffic data and send it to a processor on site for analysis; the system will then send a message to activate one or both of the flashing beacons.

Once traffic reaches speeds below 20 mph, the first beacon near the I-77 North exit ramp will activate. If traffic continues to back up toward Tryon Street, the second beacon will be activated. The contract also requires additional signage warning motorists of slow or stopped traffic.

NCDOT operates other similar detection systems on NC 58 in Carteret County, on I-26 in Polk and Henderson Counties, and on I-40 in Iredell County.

For more information on companies in this article

Related Content

  • Video as a Sensor tech drives safer roadways
    October 1, 2021
    Bosch products integrate with partner offerings to provide end-to-end ITS safety solutions
  • High-speed WIM moves onto the main highway
    May 24, 2016
    High-speed weigh-in-motion is starting to make its mark on both sides of the Atlantic. As a transit country the Czech Republic experiences a large number of overloaded vehicles, which greatly increase highway maintenance costs. This prompted its Transport Ministry to trial an extension of the capabilities of the existing truck tolling system to allow the dynamic high-speed weighing of cargo vehicles. In effect the tolling enforcement gantries become weigh-in-motion (WIM) locations.
  • Ramp metering delivers - again
    January 27, 2012
    Though still controversial, ramp metering, which has been around for nearly 50 years, continues to deliver substantial benefits, and generally for relatively small cost. Kansas City is a case in point. In March 2010, Kansas City Scout, a partnership between the Missouri and Kansas Departments of Transportation to provide ITS for the greater Kansas City Area, activated the first ramp metering system in the region. The project is located on an 8.85km (5.5 mile) section of Interstate 435 from Metcalf Avenue to