Skip to main content

Qatar tests overheight vehicle detectors

The first over-height vehicle detection system (OVDS) in Qatar has been launched at the Duhail intersection in Doha. The new system will help provide greater control over trucks and protect bridges and tunnels, the Public Works Authority (Ashghal) said yesterday. The system is operated and controlled by the traffic signal control room (TSCR) at Ashghal. The OVDS uses integrated sensors or height detectors, electronic message board and CCTV, to detect vehicles that violate the maximum permitted height of
January 6, 2014 Read time: 2 mins
The first over-height vehicle detection system (OVDS) in Qatar has been launched at the Duhail intersection in Doha.  The new system will help provide greater control over trucks and protect bridges and tunnels, the Public Works Authority (5840 Ashghal) said yesterday.

The system is operated and controlled by the traffic signal control room (TSCR) at Ashghal. The OVDS uses integrated sensors or height detectors, electronic message board and CCTV, to detect vehicles that violate the maximum permitted height of 5.5 metres before entering tunnels, or passing under bridges. In the event of any over-height vehicle trying to enter the interchange, the system will alert the vehicle through a siren audible at the site, followed by a multi-lingual text message that appears on the electronic board at the site.

At the same time, the traffic signal at the approach will be changed to red by the control room to prevent the vehicle from entering the interchange. If the vehicle ignores the warnings, the control room will immediately contact the traffic department to take steps to prevent the vehicle from entering the interchange.

Ashghal’s Road Operation and Maintenance Department is looking at the possibility of introducing the OVDS at more intersections across Doha.

For more information on companies in this article

Related Content

  • Intelligent crossing points leads to safer future for pedestrians
    May 19, 2014
    An innovative project at a busy UK retail park could provide the blueprint for a new approach to pedestrian safety, according to its developers. The system utilised hard-wired active flashing LED road studs from Rennicks UK to delineate the crossing, in conjunction with LED warning signs from Swarco. Pole-mounted C-Walk pedestrian detectors from Flir activate the high performance LED studs to create a striking visual warning for motorists approaching an internal crossing at Giltbrook, near Nottingham.
  • TfL trials cyclist detection
    June 5, 2015
    New world first trials would allow TfL to better cater for cyclists at key junctions Further on-street trials will take place later this year TfL now given blanket approval from DfT to install low-level cycle signals at junctions Transport for London (TfL) is to trial a new technology that will help give cyclists more time on green lights.
  • Sony’s vision systems help limit risk in road tunnels
    November 10, 2017
    Sony’s Stephane Clauss looks at the imaging requirements in tunnels. In the event of a fire inside a tunnel, the dispersion of gases and heat is prevented, creating extreme temperatures that have led to many deaths. Following tragic incidents including Mont Blanc, European legislation requires longer tunnels to be fitted with incident and smoke detection systems.
  • Keeping a weather eye on road conditions
    September 26, 2014
    Drive C2X has shown that advanced warning of poor road conditions could cut fatalities, as David Crawford explains. Connected vehicle (CV)-based warning technologies could mean 6% fewer deaths and 5% fewer injuries in road traffic accidents in Europe, according to the final results of the European Commission (EC) co-funded DRIVE C2X project. According to the European Centre for Information and Communication Technologies (EICT) which provided management support, these “prove that CV systems work and can hav