Kistler launches WiM system for overloads

Kistler has developed a Weigh in Motion (WiM) system which it says offers a 2% accuracy rate in gross vehicle weight independent of driving manoeuvres or road conditions.
March 18, 2020 Read time: 1 min

 

The company explains KiTraffic Digital incorporates multiple quartz crystals that independently deliver data via a digital interface. The digital measuring signal permits individual calibration of each quartz crystal and is expected to prevent signal interference on the transmission path. Algorithms work with measurement signals to calculate the wheel, axle and total weight of each vehicle.

According to Kistler, the sensor delivers reliable results when the vehicle being measured is about to overtake and is driving diagonally over the WiM sensor arrangement, while users can also monitor any number of lanes. KiTraffic Digital records information on tyre condition without the need for additional hardware and even removes the need for induction loops for vehicle detection, the company adds. The system can be integrated into third-party traffic monitoring systems.

Enforcement

For more information on companies in this article

Related Content

  • Preventing connected vehicles creating disconnected drivers
    November 12, 2015
    Advanced driver assistance systems (ADAS) are evolving at a rapid pace – but drivers’ ability to cope with them is not and at some point the mismatch must be addressed. Probably the biggest challenge the transportation industry has ever faced.” That is how Dr Bryan Reimer of Massachusetts Institute of Technology AgeLab describes the challenges posed by semi-autonomous vehicles.
    Read More
  • Close shave for Brazilian project
    June 12, 2015
    Signing the order to equip a new control room just 45 days before the city hosts a major sporting event is challenging - but some deadlines just cannot be moved. There is nothing like a deadline to concentrate minds and effort as Mitsubishi and the Brazilian city of Belo Horizonte discovered in the run-up to the 2014 World Cup. Although municipal authorities had been considering a new command centre for years, it was the hosting of the World Cup last summer that provided the final impetus.
    Read More
  • Variable message signs continue to deliver travel information
    February 2, 2012
    Arguably the 'face' of ITS, variable message signs are far from being a passing solution
    Read More
  • Navigating a path towards greater safety
    May 31, 2013
    Eric Sampson takes a look at why the European Union’s eCall system is taking rather longer to arrive than it should. There’s an old story about the person who asked an Irishman for directions and after much thought he responded: “If you’re going there from here it would be better to start from somewhere else.” This came to mind when I was recently reflecting on eCall and wondering when it will come - some stakeholders say the answer is never. So despite years of workshops and discussions, eCall is still not
    Read More

Highlighted Content