Van driver banned for ignoring motorway incident road block

A van driver who ignored a Highways England road block on the UK’s M42 motorway has been banned from driving for six months. The case highlights the need for incident zone safety: the road block had been put in place by traffic officers following a fatal crash. Richard Leonard, head of road safety at Highways England, said: “We hope this case sends out an important message because those who ignore road closures put other people’s safety in jeopardy and this was clearly the case here for our traffic officers
October 18, 2018 Read time: 2 mins

A van driver who ignored a 8101 Highways England road block on the UK’s M42 motorway has been banned from driving for six months.

The case highlights the need for incident zone safety: the road block had been put in place by traffic officers following a fatal crash.

Richard Leonard, head of road safety at Highways England, said: “We hope this case sends out an important message because those who ignore road closures put other people’s safety in jeopardy and this was clearly the case here for our traffic officers.”

Carl Phillip Bloom drove his white Mercedes van around cones via the hard shoulder on 20 January last year to avoid the road closure between junctions 2 and 1 of the southbound M42

In addition to being disqualified by magistrates in Kidderminster, Bloom was fined £880 and ordered to pay £620 costs and a £44 victim surcharge. He also had three penalty points added to his licence.

Leonard added: “Any decision to close the motorway is not taken lightly, but when this happens, drivers must obey the closure. It’s there for the safety of everyone on the road – people in difficulty, recovery and emergency services helping them, and all other road users besides.”

By law, drivers must obey directions from uniformed traffic officers, who have the power to stop and direct traffic and close lanes and carriageways.

Failure to comply carries a fine of up to £1,000 along with possible driving licence endorsement or disqualification.

Enforcement

For more information on companies in this article

Related Content

  • Jenoptik’s 100th Specs operation goes live on Grane Road
    November 8, 2017
    Jenoptik’s Specs Average Speed Enforcement Cameras have been installed between Junction 5 of the M65 near Belthorn though to A56 at Haslingden, following The Lancashire Road Safety Partnership’s plan to reduce casualties and collisions across chosen routes. The cameras are also designed with the intention of influencing driver behavior to create smoother traffic flows. Average Speed Check Signs are also being used throughout the route to ensure that drivers are aware that their speed is being monitored.
    Read More
  • Reduce fatal crashes? Get police on the road
    July 8, 2019
    There are many elements to speed enforcement - but research suggests there is a strong correlation between getting police on the roads and reducing fatal collisions There are a variety of elements which go into successful speed enforcement. The European Union’s blueprint for this (see 10 Rules…) ranges from prioritising roads to offender education courses, and from legislation to data. But research suggests that one of the key factors is visibility – drivers need to see technology in action or police on
    Read More
  • US traffic fatalities fall in 2014, but early estimates show 2015 trending higher
    December 22, 2015
    The US saw a slight decline in traffic deaths during 2014, according to the Department of Transportation's National Highway Traffic Safety Administration (NHTSA). However, an increase in estimated fatalities during the first six months of this year reveals a need to reinvigorate the fight against deadly behaviour on America's roads, NHSA says.
    Read More
  • Keeping over-height and overheating vehicles out of tunnels
    October 7, 2013
    A review of pre-warning solutions for problematic commercial vehicles approaching tunnels
    Read More

Highlighted Content