Skip to main content

Jenoptik technology for average speed enforcement pilot project

Jenoptik’s Traffic Solutions division is to participate in an 18-month Germany-wide section speed control (or average speed enforcement) pilot project. Jenoptik technology will initially be tested in Lower Saxony. Jenoptik will supply its laser scanner-based TraffiSection technology for the project in order to monitor the speed limit on a section of highway just under three kilometres in length on Federal Highway 6 south of Hanover. The system uses measuring systems and cameras installed at the entry an
February 3, 2015 Read time: 2 mins
79 Jenoptik’s Traffic Solutions division is to participate in an 18-month Germany-wide section speed control (or average speed enforcement) pilot project. Jenoptik technology will initially be tested in Lower Saxony.

Jenoptik will supply its laser scanner-based TraffiSection technology for the project in order to monitor the speed limit on a section of highway just under three kilometres in length on Federal Highway 6 south of Hanover.  The system uses measuring systems and cameras installed at the entry and exit points of an extended stretch highway to record vehicle licence plate data and measure average speed between the two points.

If a vehicle’s average speed over the section of highway exceeds the maximum permitted, a conventional high-resolution frontal photograph is taken with driver recognition when the vehicle exits the section of the highway. The system automatically records data such as the licence plate and a photograph of the driver for use in a later prosecution.

All data are encrypted and details of vehicles that have not exceeded the speed limit are stored only temporarily.

The system will be installed by the end of March 2015 and the test phase will start in April. Approval for Germany is to be obtained from the Germany’s national metrology institute Physikalisch-Technische Bundesanstalt (PTB) in the course of this year which will allow the system to go into full operation, probably in autumn of 2015.

Jenoptik president and CEO Michael Mertin commented: “We are pleased that we can support such a trend-setting project in Germany with our experience. Our modern technology for section speed control has already contributed to increase traffic safety in other countries. It has been used successfully for several years in the United Kingdom, in Austria and Switzerland as well as in Kuwait.”

For more information on companies in this article

Related Content

  • New York City plans to test speed cameras
    March 14, 2013
    New York state and local leaders are considering a bill that would enable New York City to install up to forty stationary and roving speed cameras at high-risk locations for the next five years. The calls for a crackdown on speeding come after several high-profile crashes. One in four traffic deaths in New York City is caused by speeding. In 2011 alone, 70 people were killed and 4,700 people were injured as a result of speed-related crashes in the five boroughs. “Speeding is the number one cause of fatal c
  • Monitoring, detection and control systems inside tunnels can do much to improve traveller safety
    August 6, 2013
    ITS technology can do a great deal to improve tunnel safety, as Colin Sowman discovers. It was back in April 2004 that the European Parliament adopted the EU Directive which lays down the Minimum Safety Requirements for Tunnels in the Trans-European Road Network (2004/54/EC). This was the first unitary legislation setting minimum safety standards for European road tunnels and was designed to harmonise the management of tunnel safety at a national level. Operators of existing tunnels have until 30 April 201
  • Kistler offers flexible WiM solution
    April 13, 2021
    KiTraffic Plus sensors capture weight of trucks at speeds of up to 120 km/h
  • Ouster Lidar aids German V2X plans 
    November 3, 2021
    Researchers built 60 mobile measuring stations to be deployed across a 4.3km stretch