Skip to main content

Jenoptik technology for average speed enforcement pilot project

Jenoptik’s Traffic Solutions division is to participate in an 18-month Germany-wide section speed control (or average speed enforcement) pilot project. Jenoptik technology will initially be tested in Lower Saxony. Jenoptik will supply its laser scanner-based TraffiSection technology for the project in order to monitor the speed limit on a section of highway just under three kilometres in length on Federal Highway 6 south of Hanover. The system uses measuring systems and cameras installed at the entry an
February 3, 2015 Read time: 2 mins
79 Jenoptik’s Traffic Solutions division is to participate in an 18-month Germany-wide section speed control (or average speed enforcement) pilot project. Jenoptik technology will initially be tested in Lower Saxony.

Jenoptik will supply its laser scanner-based TraffiSection technology for the project in order to monitor the speed limit on a section of highway just under three kilometres in length on Federal Highway 6 south of Hanover.  The system uses measuring systems and cameras installed at the entry and exit points of an extended stretch highway to record vehicle licence plate data and measure average speed between the two points.

If a vehicle’s average speed over the section of highway exceeds the maximum permitted, a conventional high-resolution frontal photograph is taken with driver recognition when the vehicle exits the section of the highway. The system automatically records data such as the licence plate and a photograph of the driver for use in a later prosecution.

All data are encrypted and details of vehicles that have not exceeded the speed limit are stored only temporarily.

The system will be installed by the end of March 2015 and the test phase will start in April. Approval for Germany is to be obtained from the Germany’s national metrology institute Physikalisch-Technische Bundesanstalt (PTB) in the course of this year which will allow the system to go into full operation, probably in autumn of 2015.

Jenoptik president and CEO Michael Mertin commented: “We are pleased that we can support such a trend-setting project in Germany with our experience. Our modern technology for section speed control has already contributed to increase traffic safety in other countries. It has been used successfully for several years in the United Kingdom, in Austria and Switzerland as well as in Kuwait.”

For more information on companies in this article

Related Content

  • France extends mobile speed enforcement
    April 25, 2016
    The French Ministry of the Interior plans to extend the country’s nationwide speed enforcement and has ordered an additional 100 enforcement trailers from Vitronic. The autonomous mobile Lidar-based systems utilise Vitronic's Poliscan speed technology and can operate autonomously for a minimum of five days. They will mainly be deployed on the French National Road network. Vitronic supplied 150 trailers in April 2015 and says the systems have proved to be effective, with single units documenting up to 2,500
  • Jenoptik enforcement action begins in Maryland
    August 22, 2024
    Systems in Prince George’s County contain Vector SR camera and a radar sensor
  • New world record for fastest car on ice
    March 1, 2012
    A new world record for the fastest car on ice has been set this week by Nokian Tyres' test driver Janne Laitinen who drove 331.610 km/h (206.05 mph) on the Gulf of Bothnia in Oulu, Finland.
  • Need for secure approach to connected vehicle technology
    January 7, 2013
    Accidental or malicious issue of false messages to connected vehicles could result in dire consequences, so secure systems of authentication and certification are likely to be necessary, write Paul Avery and Sandra Dykes. Connectivity among vehicles in urban traffic systems will provide opportunity for beneficial impacts such as congestion reduction and greater safety. However, it also creates security risks with the potential for targeted disruption. Security algorithms, protocols and procedures must take