Intercomp launches LS-WiM system for fleet operators

Intercomp has launched a low-speed Weigh in Motion (LS-WiM) system which it says allows fleet managers to collect the weight of vehicles without hampering traffic flow. The system is suitable for high-volume entry and exit gates and, unlike full-length truck scales, does not require incoming and outgoing traffic to stop every time a vehicle needs to be weighed, the company adds. According to Intercomp, the system’s small footprint allows it to be installed at most facilities at approximately half the co
February 28, 2019 Read time: 1 min
1982 Intercomp has launched a low-speed Weigh in Motion (LS-WiM) system which it says allows fleet managers to collect the weight of vehicles without hampering traffic flow.


The system is suitable for high-volume entry and exit gates and, unlike full-length truck scales, does not require incoming and outgoing traffic to stop every time a vehicle needs to be weighed, the company adds.

According to Intercomp, the system’s small footprint allows it to be installed at most facilities at approximately half the cost compared to traditional full-length truck scales. It can weigh vehicles travelling up to 10mph.

The solution is expected to provide efficient verification of individual axle weights, axle groups and gross vehicle weights, which law enforcement agencies use to determine compliance of commercial vehicles.

Enforcement

For more information on companies in this article

Related Content

  • IRD awarded Wisconsin weigh-in-motion project
    January 21, 2015
    International Road Dynamics (IRD) has been awarded a US$1.7 million contract by Chippewa Concrete Services of Wisconsin to supply, install and maintain a weigh-in-motion (WIM) sorting system at the Douglas County Safety and Weight Enforcement Facility (SWEF). The project is to be completed by the summer of 2016. IRD will supply and install its patented WIM scales, iSINC electronics, video verification system, vehicle movement compliance system and associated operational software. The system will allow
    Read More
  • IRD customised weight enforcement system goes live in Spokane
    June 14, 2012
    International Road Dynamics (IRD) has been working with the Washington State Patrol (WSP) and the Washington State Department of Transportation (WSDOT) to support delivery of a customised weight enforcement and commercial vehicle inspection solution which integrates vehicle identification, credential screening and data collection for the Spokane Port-of-Entry (POE) Weigh Station on I-90. Yesterday, the station’s grand opening was held at the POE which is located on Interstate 90 one mile west of the Washing
    Read More
  • Idaho WIM systems save trucking industry time and money
    September 5, 2017
    Figures released by the Idaho Transportation Department indicate that weigh-in-motion (WIM) systems installed at the state’s four points of entry (POE) have saved the trucking industry time and money in the last year. The data shows that trucks bypassing the port save an average of five minutes of time per incident, and almost a half a gallon of fuel. This amounts to a savings of about US$8.68 per bypass. Commercial trucks using WIM to bypass Idaho ports saved 33,365 hours and more than 16,000 gallons of
    Read More
  • WiM eases structural health worries
    February 12, 2024
    Concerns about infrastructure are leading road authorities to consider the importance of Weigh in Motion solutions to monitor the wellbeing of their roads – and particularly bridges – finds Adam Hill
    Read More

Highlighted Content