Skip to main content

Australia assesses 30km/h safety benefits

Trial in Yarra near Melbourne found that vehicle speeds fell and residents approved
By Ben Spencer May 6, 2021 Read time: 2 mins
Australia findings give support for the likely safety benefits of the 30km/h trial (© Björn Wylezich | Dreamstime.com)

Australia's Monash University Accident Research Center has evaluated the benefits of a 30km/h speed limit trial in Yarra, near Melbourne. 

The city has a 40 km/h default speed limit, but wanted to reduce it in local residential streets.

A 'before and after' trial design was employed with a control (untreated) area to evaluate the safety outcomes. 

Speed limits were reduced in a trial area but remained at 40km/h in the control region.

Vehicle speeds were measured at around 100 selected sites in the trial and control areas, and resident surveys were undertaken in both regions before and after the trial.

In a paper available online, results show a reduction of 1.1% in average speed in the trial region but a surprising 2.7% in the control region. 

On further examination, it found significant reductions in the percent of vehicles exceeding 40km/h and 50km/h in both the treated and control regions, but not at 30km/h.

The survey results found increased support for the lower speed limit of 17% with little adverse consequences.

The findings give support for the likely safety benefits of the 30km/h trial with increased support from residents. 

According to the paper, speed reductions in the control region suggested a carry-over of the effects of the trial but also added support by local residents for reduced speed limits in the region.

Potential injury savings were estimated at a 4% reduction in the risk of a pedestrian injury from the observed treatment effect in the trial region. 
 

For more information on companies in this article

Related Content

  • Mounting benefits of dynamic tolling project
    January 30, 2012
    Wisconsin's four-year HOT lanes pilot project, launched in May 2008, cost US$18.8 million to construct. Halfway into the project, which uses variably priced, or dynamic, tolling to improve highway efficiency, the benefits are mounting. The problem was obvious, and frustrating, to anyone who ever sat in bumper-to-bumper traffic on State Route 167 and watched a lone car whiz by every 20 seconds or so in the carpool lane. But for planners at the Washington State Department of Transportation, the conundrum was
  • Government incentives ‘vital to help OEMs tackle costs for gasoline particulate filters’
    November 2, 2015
    According to the latest analysis from Frost & Sullivan, the competitive, growing gasoline particulate filters (GPFs) market in Europe and North America presents suppliers and original equipment manufacturers (OEMs) with diverse opportunities as well as challenges. The inclusion of particulate number regulation within emission norms will accelerate the adoption of GPFs. However, government incentives will be vital to help OEMs tackle the rising costs of GPF installations. The analysis, Analysis of the GP
  • Safety drive finds speed violators on Kansas highways
    September 9, 2024
    Kansas DoT's five-year Safety Corridor Pilot Program reaches end of first year
  • In-vehicle fleet management system reduces losses
    May 4, 2012
    Loomis offers products and services that provide complete cash logistics solutions for financial institutions, retailers and other commercial enterprises. The company is present in twelve European countries and the USA and has just over 20,000 employees. At Loomis safety is considered good business. Presented with the opportunity to reduce both accident frequency and associated primary liability costs, the company equipped the majority of its US armoured truck and van fleet with the Driver Safety Measuremen