Skip to main content

Sweden winning over doubters

Comparatively little negative comment has been made in Swedish media with regard to the country’s widespread speed enforcement, according to project manager Eva Lundberg of Trafikverket, Sweden’s Transport dministration. Lundberg is due to give a presentation at the Vienna World Congress special session on enforcement, probably with more than a passing word on public acceptance. Trafikverket has put a lot of work into its Vision Zero road safety strategy over the past few years; much of it targeting reducti
December 4, 2012 Read time: 3 mins
Sweden has increased speed limit compliance from 50% to above 80% (95% at camera sites), according to Trafikverket reports
Comparatively little negative comment has been made in Swedish media with regard to the country’s widespread speed enforcement, according to project manager Eva Lundberg of 6301 Trafikverket, Sweden’s Transport Administration. Lundberg is due to give a presentation at the Vienna World Congress special session on enforcement, probably with more than a passing word on public acceptance.

Trafikverket has put a lot of work into its Vision Zero road safety strategy over the past few years; much of it targeting reduction of traffic speeds. Since Vision Zero and an associated programme of enforcement were initiated in the late 1990s, Sweden has increased speed limit compliance from 50% to above 80% (95% at camera sites), according to Trafikverket reports.

Sweden now has 1100 speed enforcement cameras, but of the roughly 230,000 drivers recorded exceeding the speed limit last year, only around a third were penalised (the remainder were motorcyclists, foreign drivers or could not be recognised). “We do not see this as a problem,” Lundberg says. “The whole idea was to improve safety, partly by reducing traffic speeds. We have reduced fatalities by half, which is more important than numbers successfully prosecuted.”

The casualty reduction, Lundberg says, has been achieved by changing the mindset of drivers in Sweden, by alerting them to the criticality of certain speed thresholds for surviving collisions, and reducing speed limits accordingly at high risk sites. Other aspects of the Vision Zero policy have brought improvements to road infrastructure, such as introduction of barriers to 2+1 road layouts and a raft of urban safety initiatives.

“Where parts of the road network have experienced high numbers of fatalities, if we cannot upgrade the road then we put up cameras. It’s an engineering decision taken with comparison to other engineering options. The important thing is to inform the public of the cameras and why they are being placed there,” says Lundberg.
Matts-Ake Belin, project manager of Trafikverket’s Vision Zero Academy, has recently completed a PhD study ‘Target Zero’ in road safety. He says:

“A comparative study of approaches to speed enforcement adopted in Sweden and the State of Victoria in Australia found subtle but fundamental differences in the ideas underpinning each initiative.

In both cases the aim was to reduce traffic speed with technology.

In Victoria a strong deterrent was sought – for making drivers feel they can be caught at any time. This was successful, with fixed and mobile cameras, but the momentum has to be maintained.

“There are disputes in Australia over the motives of speed enforcement, but none such in Sweden, where there are now about 10 times as many cameras.

In Sweden it was often the road system that was at fault. Trafikverket wanted to change the perception and give the impression that changes have been made because the road was far too dangerous before.”

Alterations to Sweden’s road network have included introduction of variable speed limits at high risk sites such as road junctions or intersections, with speeds typically adjusted from 90km/hr down to 70km/hr depending on weather conditions, traffic flow and other circumstances. A field trial found that varying limits – shown on 537 VMS signs – reduced speeds by 5-15km/hr.

“Traditionally our approach was towards people not willing to comply with speed limits, but we now find most people do
not want to speed and so we are focusing on more support for them with better design of the road system,” Lundberg says. “We are planning to expand speed enforcement, with further communication initiatives through the media, transport authorities and police.”

Related Content

  • March 18, 2020
    VRU safety report urges enforcement
    Enforcement must be at the heart of a drive to reduce vulnerable road user deaths and injuries, says the latest report from the European Transport Safety Council. Its facts and figures give authorities the justification to invest more in camera technology and other ITS solutions
  • January 30, 2012
    Road design as a primary aid to speed enforcement?
    Letty Aarts, senior researcher, SWOV institute for road safety research, the Netherlands, discusses how road design can act as a primary aid to speed enforcement
  • October 18, 2013
    Spot speed deterrent proved to be transient
    As research and trials show the benefits of average speed enforcement - David Crawford reviews developments on two continents. August 2013 saw the switch on of the Australian State of Victoria’s latest combined point-to-point (P2P) average speed enforcement (ASE) and spot camera control system. Installed on the 27km Peninsula Link to the south-east of Melbourne, the system uses high-resolution automatic number plate recognition (ANPR) cameras and optical character recognition (OCR) technology developed b
  • March 19, 2015
    Further ATC order for Sensys in Sweden
    Sensys Traffic has received an order from the Swedish Transport Administration for installation works for the Swedish automatic traffic safety control (ATC) system. Worth US$575,000, the order comprises additional installation works and installation material and is an extension of Sensys' services in connection with the installation of new ATC stations in Sweden in 2015. Sensys won an order for new and replacement systems and cabinets worth SEK 93m in November 2014, and an additional order for installation