Skip to main content

Toyota to fit selected new cars with advanced automotive safety system

Beginning in 2015, some of Toyota Motor Corporation's new models will be compatible with advanced vehicle-infrastructure cooperative systems that use a wireless frequency reserved for intelligent transport systems (ITS). This compatibility will be offered as an option for the Toyota Safety Sense P active safety package that will be made available in 2015 on selected new models sold in Japan. The systems will use the dedicated ITS frequency of 760 MHz for road-to-vehicle and vehicle-to-vehicle communicati
November 28, 2014 Read time: 2 mins
Beginning in 2015, some of 1686 Toyota Motor Corporation's new models will be compatible with advanced vehicle-infrastructure cooperative systems that use a wireless frequency reserved for intelligent transport systems (ITS). This compatibility will be offered as an option for the Toyota Safety Sense P active safety package that will be made available in 2015 on selected new models sold in Japan.

The systems will use the dedicated ITS frequency of 760 MHz for road-to-vehicle and vehicle-to-vehicle communication to gather information that cannot be obtained by onboard sensors. At intersections with poor visibility, information about oncoming vehicles and pedestrians detected by sensors above the road will be conveyed via road-to-vehicle communication, and information about approaching vehicles will be conveyed via vehicle-to-vehicle communication, with audio and visual alerts warning drivers when necessary.

In addition, Toyota's newly-developed communicating radar cruise control feature allows preceding and following vehicles to maintain safe distances between one another on highways.

Communicating radar cruise control uses Toyota's existing forward-facing millimetre-wave radar to detect inter-vehicular distances and relative speeds. The addition of acceleration and deceleration information from preceding vehicles (obtained via vehicle-to-vehicle communication) significantly enhances tracking performance. In addition to making highway driving safer, this helps reduce traffic congestion and enables more fuel-efficient driving.

For more information on companies in this article

Related Content

  • New research: to illuminate or not to illuminate
    February 5, 2013
    Researchers from the US Lighting Research Center (LRC) and Penn State University have recently published a paper entitled “To illuminate or not to illuminate: Roadway lighting as it affects traffic safety at intersections”. Published in the journal Accident Analysis and Prevention the paper describes a parallel approach to lighting safety analysis. Tackling the tricky questions of when and where to install roadway illumination, while at the same reducing municipal costs, is a challenge for transportation a
  • What's next for traffic management and data collection?
    January 26, 2012
    As the technologies and stakeholders in traffic management evolve, what can we expect to see happening in the coming years? For many, the conversation of the moment is just how, and how far, the newer technologies and services provided principally by the private sector should be allowed to intrude into the realms of traffic management.
  • Progressing work zone safety systems
    February 1, 2012
    David Crawford investigates progress in a key safety area - work zones. Highway construction zone safety is taken seriously enough in the US to merit a special spring National Work Zone Awareness Week, which in 2010 ran from 19-23 April. Headed by the US Department of Transportation's Federal Highway Administration (FHWA), this aims to reduce an annual toll of work zone deaths - 720 in 2008 (an average of one every 10 hours) with more than 40,000 traffic injuries (an average of one every 13 minutes).
  • Progressing work zone safety systems
    February 6, 2012
    David Crawford investigates progress in a key safety area - work zones