Autotalks selected by Denso for mass market V2X system

Israeli company Autotalks is to supply its V2X chipset to auto parts supplier Denso for its global V2X platform for mass market projects. Designed to meet the latency requirements for safety applications, Autotalks' next generation devices embed a mobility optimised modem, support dual-antenna with optimal and flexible RX/TX diversity, perform line-rate message ECDSA verification of the entire link capacity and embed an ultra-low-latency V2X HSM. In addition, the device was designed for crypto-agility an
September 29, 2016 Read time: 2 mins
Israeli company 6765 Autotalks is to supply its V2X chipset to auto parts supplier Denso for its global V2X platform for mass market projects.

Designed to meet the latency requirements for safety applications, Autotalks' next generation devices embed a mobility optimised modem, support dual-antenna with optimal and flexible RX/TX diversity, perform line-rate message ECDSA verification of the entire link capacity and embed an ultra-low-latency V2X HSM. In addition, the device was designed for crypto-agility and scalability and is capable of operating at a high temperature range. According to Autotalks, its communication range can reach hundreds of metres and even more than 1km in some conditions.

The prototyping phase has already begun, geared towards the start of high-volume production in 2019, targeting North America market for applications including green light speed advisory, road works warning, and safety applications such as intersection movement assist, emergency vehicle approaching etc. The companies plan to introduce autonomous driving capabilities in the same time frame, including truck platooning.
Location Based Systems

For more information on companies in this article

Related Content

  • Cohda Wireless: 'New York has the best urban canyons'
    July 21, 2020
    Dr Paul Alexander, chief technical officer of Cohda Wireless, talks to Adam Hill about DSRC versus C-V2X, global connected vehicle take-up, the uses of WiFi – and, of course, seeing round the Big Apple's buildings...
    Read More
  • 3M reflect on why CAVs need lines and signs
    May 10, 2017
    Tammy Meehan and Thomas Hedblom of 3M consider the ongoing development of technology needed to introduce connected and autonomous vehicles. The transportation industry is in the midst of the most dramatic shift since Henry Ford introduced horseless carriages. Already we are seeing the increased use of advanced driver assistance systems (ADAS) which, along with the introduction of autonomous vehicles in the next few decades, will bring profound changes to vehicles and the environment in which they operate.
    Read More
  • On a WIM – a global view of weigh in motion
    May 25, 2016
    Q-Free’s Andrew Lees looks at regional characteristics and technology trends in the global Weigh-In-Motion market. The principles of Weigh-In-Motion (WIM) are well established. Data derived from vehicles passing over in-ground sensors can be interpreted for vehicle classification (axle counts and spacing) and positive identification (especially when linked to image capture) applications as well as to derive individual axle and gross vehicle weight (GVW).
    Read More
  • Electronic toll collection: Change is in the air
    November 7, 2024
    Trends in technology plus users’ comfort in adopting new advances indicate that the environment for a new electronic toll collection architecture is evolving. Hal Worrall considers what this might look like
    Read More

Highlighted Content