Skip to main content

Bluetooth travel information aids waiting times at US-Mexico border

With drivers sometimes waiting up to several hours to cross the US-Mexico border, the Texas Department of Transportation (TXDOT) is partnering with the city of El Paso to provide real-time traffic updates so drivers can plan accordingly and avoid long waits. Using Bluetooth and radio-frequency identification (RFID) technology, wait times will be available to motorists and commercial shippers so they can modify travel plans as needed. As Bluetooth devices in passenger vehicles and RFID transponders in com
August 12, 2014 Read time: 2 mins

With drivers sometimes waiting up to several hours to cross the US-Mexico border, the 375 Texas Department of Transportation (TXDOT) is partnering with the city of El Paso to provide real-time traffic updates so drivers can plan accordingly and avoid long waits. Using Bluetooth and radio-frequency identification (RFID) technology, wait times will be available to motorists and commercial shippers so they can modify travel plans as needed.

As Bluetooth devices in passenger vehicles and RFID transponders in commercial vehicles pass roadside sensors, bridge wait times are calculated and posted at the border crossing information system (BCIS) website. Drivers can access this site and make decisions on when to leave based on the real-time wait times. The data is used only temporarily and does not identify actual drivers or their vehicles.

The BCIS website was developed through research by the Texas A&M Transportation Institute and partially funded by the 324 US Department of Transportation’s 831 Federal Highway Administration.

Currently, drivers can utilise the new Bluetooth-generated data for the Ysleta crossing, also known as Zaragoza and located between El Paso and Ciudad Juarez. Shippers can access similar data generated via RFIDs at seven sites along the border. Bluetooth technology also is in use along I-35 in Waco and at the Port Aransas Ferry, where waiting times are posted onto digital message boards.

“Texas is proud to lead the way in transportation technology, especially when it helps relieve congestion and improve mobility at key points on our roadways,” said chairman Ted Houghton, 5427 Texas Transportation Commission. “Not only will this technology benefit travellers, but it will benefit our state’s commerce by making trade more efficient.”

“The city of El Paso’s economic security depends on the flow of goods and people across our international ports of entry,” said El Paso Mayor Oscar Leeser. “In order to ensure safe and fast commute times, we must provide our commuters access to realistic wait times. The partnership between the city of El Paso and TxDOT is a significant step in helping these commuters identify the best route and provide realistic crossing times at our bridges.”

Related Content

  • Big data bonus for Dublin’s buses
    August 19, 2014
    Dublin’s smart research partnership speeds buses More than 50% of people travelling into and across the Irish capital rely on public transport, and four out of 10 these use buses meaning Dublin Bus carries some 120 million passengers a year.
  • System predicts train delays and informs response
    February 25, 2016
    David Crawford looks into the near-term future for Stockholm’s rail commuters. Swedish rail operator Stockholmståg, which runs commuter services in and around the country’s capital, is claiming a world first with the introduction of its automated Pendelprognosen (commuter prognosis) service. Developed to enable the prediction of delays as much as two hours before they are likely to occur, this offers the operator the scope for much earlier remedial action than previously - for example by filling in the expe
  • LiDAR sets its sights on future problems
    February 23, 2017
    AAdvances in LiDAR are helping transport authorities improve services and identify potential problem areas, as geospatial technology expert Dr Neil Slatcher explains. The effects of climate change on the transport infrastructure have long been a cause of concern within the transportation sector - and not only on the structures themselves but also on the surrounding areas. This year, those concerns have become reality with landslides, structural collapses and surfacing issues impacting services across the wo
  • Mobinet counters weighty cross border concerns
    November 9, 2017
    A Mobinet pilot is combining onboard weighing with V2X comms to streamline vehicle weight enforcement. David Crawford reports. Pan-European, cross-border weigh-in-motion (WIM) for trucks is now a practical possibility, following successful Scandinavian trials within the EU-co-funded Mobinet (Internet of Mobility) programme. New technology is using strain sensors, located on load-bearing components and routinely installed in truck fleet management systems.