Skip to main content

US judge finds in favour of Kapsch in legal action on tolling products

Kapsch TrafficCom North America is pleased to report that the US International Trade Commission (ITC) judge has ruled in its favour in a legal action brought by Neology, seeking to prevent Kapsch from importing certain electronic tolling products using the ISO/IEC 18000-6C communications protocol (6C Standard).
June 26, 2017 Read time: 2 mins

4984 Kapsch TrafficCom North America is pleased to report that the US International Trade Commission (ITC) judge has ruled in its favour in a legal action brought by Neology, seeking to prevent Kapsch from importing certain electronic tolling products using the ISO/IEC 18000-6C communications protocol (6C Standard).

Kapsch believes that the 6C Standard is a truly open communications protocol, and the ITC’s initial determination in this case supports this position, stating that the patents asserted by Neology are invalid.

Chris Murray, president and CEO of Kapsch TrafficCom North America, says of the decision, “Kapsch will continue to advocate for open-communication and RFID standards. This is to the good of the consumers and the entire economy as it facilitates national electronic tolling interoperability.”

Kapsch has been a strong proponent of open standards and interoperability within the electronic tolling solutions industry and market. Open standard communication protocols are critical to meeting the goals of the US Moving Ahead for Progress in the 21st Century Act (MAP-21), enacted in 2012, which mandates national agreement on tolling technologies and business practices to facilitate national electronic tolling interoperability. In support of this, Kapsch released and published its Open Standard Time Division Multiplexing (TDM) specification to the public in 2013, enabling open and free access to developers seeking to work with and implement the highly reliable and thoroughly tested TDM specification. The TDM protocol is currently utilised by the E-ZPass® Group, the largest interoperable tolling network in the country.

For more information on companies in this article

Related Content

  • On-road and in-vehicle are not in competition
    May 18, 2018
    The integrity and accuracy of data that can be verified by weigh-in-motion technology has been improving for decades – and the range of WIM applications is increasing at a tremendous pace. Chris Koniditsiotis, president of the International Society for Weigh-in-Motion (ISWIM) and CEO of Transport Certification Australia (TCA), began his career in 1985 as a pavements engineer. “When I joined this portfolio, the integrity, accuracy, and sampling frequency of mass information delivered at best an estimate, us
  • New US fuel efficiency standards would cost over US$65 billion in lost revenue
    April 17, 2012
    Friday’s proposal by the Obama Administration to increase fuel efficiency standards for cars and light trucks to an average 54.5 miles per gallon (4.32 litres/100 km) between 2017 and 2025 would result in the loss of more than $65 billion in federal funding for state and local highway, bridge and transit improvements, an analysis by the American Road & Transportation Builders Association (ARTBA) shows.
  • Use tolling to help rebuild interstate highways
    August 21, 2014
    Following the passage of the short-term Highway Trust Fund bill, Patrick Jones, CEO of the International Bridge, Tunnel and Turnpike Association, writing in Roll Call, writes that states should now be focused on capitalising on a key part of the Grow America Act, which will lift the ban on interstate tolling, allowing states to determine how to fund reconstruction of interstate highways. He says that now that Congress has ‘patched’ the Highway Trust Fund to save it from insolvency, it is time to get some
  • Econolite keeps an open mind
    May 11, 2021
    If we’re going to take advantage of new technologies to improve safety, collaboration at the traffic management cabinet edge is vital, thinks Eric Raamot of Econolite