Skip to main content

Upgrade for Minnesota’s tolling system data integration

Following the US Department of Transportation’s Urban Partnership Agreement’s award to Minnesota DOT of the necessary funds to improve traffic flow on I-35W to and from downtown Minneapolis, Comtrol's DeviceMaster RTS 1-port was implemented to provide an Ethernet connection between all the toll tag readers along the I-35W corridor. The project consisted of retrofitting existing high-occupancy vehicle (HOV) lanes with technology that would enable single-occupant vehicles to use the HOV lanes. The toll lan
May 31, 2016 Read time: 2 mins
Following the 324 US Department of Transportation’s Urban Partnership Agreement’s award to Minnesota DOT of the necessary funds to improve traffic flow on I-35W to and from downtown Minneapolis, Comtrol's DeviceMaster RTS 1-port was implemented to provide an Ethernet connection between all the toll tag readers along the I-35W corridor.

The project consisted of retrofitting existing high-occupancy vehicle (HOV) lanes with technology that would enable single-occupant vehicles to use the HOV lanes. The toll lane had to be dynamically priced, meaning the toll rate would increase as traffic on the main lanes increased, allowing vehicles travelling in the high-occupancy toll (HOT) lane to maintain a speed of 55mph at all times no matter how congested the main lanes were, while an RFID toll tag in the vehicle registers the toll charge. Comtrol’s DeviceMaster gathers the serial information from each toll tag reader and transmits it via Ethernet to the main control.

For more information on companies in this article

Related Content

  • Alliance stages North American back office interoperability trial
    December 4, 2013
    JJ Eden, President and CEO of the Alliance for Toll Interoperability, talks to Jason Barnes about the new inter-agency hub, which will facilitate national transactions When it comes to achieving interoperability, the sheer diversity of technologies in operation in the US is perhaps the tolling industry’s greatest defining characteristic and its biggest challenge. The situation is in stark contrast with some other regions of the world, such as Europe where the use of common front-end Dedicated Short-Range
  • Tyne & Wear signal upgrade aids bus times
    December 3, 2012
    Siemens is to upgrade over 160 traffic signal controllers across the UK’s Tyne & Wear region following the award of Government Better Bus Area (BBA) funding to the Tyne & Wear Integrated Transport Authority. The project aims to improve the reliability of journey times along 19 bus corridors and relieve congestion at nine hotspots where buses are currently regularly delayed. Siemens will upgrade and connect traffic controllers to its Remote Monitoring System (RMS) and provide the Tyne & Wear urban traffic co
  • ITS advancement lays beyond benefit-cost analysis
    May 29, 2013
    Shelley Row, former Director of the US Department of Transportation’s ITS Joint Program Office, gives her views on the way forward for the industry. We, as intelligent transportation system (ITS) proponents and engineers, tend to be overly fixated on benefit-cost data. We want decisions to be made on logical grounds for which benefit-cost calculations are optimal. While benefit-cost data is necessary, it is not always sufficient. We can learn from our history where we see three broad groups of ITS deploymen
  • SESA completes Phase 2 of Michigan DOT sign project
    December 9, 2016
    Dynamic LED sign manufacturer SES America (SESA) has completed the installation and commissioning of seven dynamic message signs (DMS) signs along part of I-75 in Michigan. The signs were installed by J. Ranck Electric as part of the second phase of a project with the Michigan Department of Transportation (MDOT) and utilised SESA’s unique Messenger 5000 embedded DMS technology to display toll rate, lane status, and traffic control information. This operation is the second phase of a collaboration betw