Skip to main content

New York State Thruway to go all electronic

The New York State Thruway is converting two mainline and one side toll plaza to all electronic (AET) or cashless toll collection, in a drive to contain spiralling employee costs and debts caused by a reduction in traffic. Although the original plan called for open road tolling (ORT) plus a cash toll plaza, the Request for Proposals for the new bridge allowed bidders to propose AET during the construction if that reduced disruption of traffic. Work is now starting on the new bridge which under the contract
February 21, 2013 Read time: 2 mins
The New York State Thruway is converting two mainline and one side toll plaza to all electronic (AET) or cashless toll collection, in a drive to contain spiralling employee costs and debts caused by a reduction in traffic.

Although  the original plan called for open road tolling (ORT) plus a cash toll plaza, the Request for Proposals for the new bridge allowed bidders to propose AET during the construction if that reduced disruption of traffic.

Work is now starting on the new bridge which under the contract is due for completion by April 2018. The new bridge will be located immediately north of the existing bridge and the first traffic to be moved from the old bridge will be the non-toll northbound traffic. The old toll plaza will probably stay in service for at least the first half of construction. The new AET system seems likely to be needed some time in 2015 or 2016.

The move to AET will reduce the capital costs of the new bridge project which includes the new Tappan Zee toll plaza. The ORT plus cash toll plaza as originally planned would have cost an estimated US$61 million. AET with gantries over four or five lanes is mush less - of the order of US$10 million to US$15 million in capital and setup costs.  AET also has clear advantages over ORT in safety (less driver distraction, no diverge/merge movements, fewer speed changes) and in environmental impacts (less idling and acceleration to generate tailpipe emissions, smaller paved footprint.)

Related Content

  • Austria’s answer to temporary traffic problems
    December 22, 2015
    ASFINAG has developed a mobile traffic monitoring and guidance system through a pre-commercial procurement project. Drivers have become accustomed to roadside and gantry-mounted traffic guidance and control systems along the major roads and main motorway sections. But there are occasions when intense monitoring is required on a temporary basis along motorway sections without traffic guidance and control systems and on federal and national roads too. Examples include the monitoring of the traffic flow during
  • Bill Halkias: 'We need a sustainable world'
    April 20, 2021
    In the first of our Tolling Matters interview series, Bill Halkias, MD & CEO of Attica Tollway Operations Authority and president of the International Road Federation, talks to Adam Hill about post-Covid recovery and sustainable mobility
  • Benefits of traffic light synchronisation
    January 27, 2012
    Alicia Parkway corridor, located in Orange County, California, was part of Phase 1 of an inter-jurisdictional Traffic Light Synchronisation Programme (TLSP) in Orange County designed to increase mobility and overall drive quality while reducing fuel consumption and greenhouse gas emissions. By increasing average speeds and reducing travel times via the reduction in stops, the programme sought to reduce vehicle acceleration and deceleration events along the corridor; these have been identified as the leadin
  • Cellint measures speed and travel time without roadside infrastructure
    April 10, 2014
    Collecting speed and travel time data without using roadside infrastructure could offer new possibilities to cash-strapped road authorities. Streaming video may be useful for traffic controllers to monitor incidents and automatic number plate recognition may be required for enforcement, but neither are necessary for many ITS functions. For instance travel times, tailbacks, percentage of vehicles turning, origin and destination analysis can all be done using Bluetooth and/or WI-Fi sensors and without video o