EU electronic toll service has fallen behind schedule

According to a recent report by the European Commission, EU member states are far behind schedule in implementation of the European Electronic Toll Service (EETS). It is already clear that the target date of 8 October 2012 for heavy duty vehicles will not be met. The system is designed to enable road users to pay tolls throughout the EU with one subscription contract, one service provider and one on-board unit. The aim is to eliminate cumbersome procedures for cross-border users. The legislation requires me
September 10, 2012 Read time: 2 mins
According to a recent report by the 1690 European Commission, EU member states are far behind schedule in implementation of the European Electronic Toll Service (EETS). It is already clear that the target date of 8 October 2012 for heavy duty vehicles will not be met.

The system is designed to enable road users to pay tolls throughout the EU with one subscription contract, one service provider and one on-board unit. The aim is to eliminate cumbersome procedures for cross-border users. The legislation requires member states to open their tolling systems to commercial EETS providers. EETS must be available to all vehicle categories by October 2014.

The report blames incomplete national transposition of the required rules in most member states. There has also been a delay in the necessary investment in both the systems and the resting required by toll chargers.

In response to the report, the Commission has published a warning that it will launch infringement proceedings against member states that fail to meet their obligations to roll out the service. But it also lays out possible assistance the Commission could offer to help speed up the roll-out, including financial assistance for interoperability projects between member states, under the trans-European transport programme.
Charging, Tolling & RUC

For more information on companies in this article

Related Content

  • Tolling system interoperability gains momentum
    August 14, 2012
    Efforts to advance national interoperability for tolling systems are gaining momentum, with one protocol promoted by a key operator group emerging as a candidate to form the basis for full AVI interoperability, Tim McGuckin writes. Fuelled by a growing awareness and acceptance of standards-based solutions, the US toll community is quickening towards the goal of interoperability between toll systems across the US. Over 20 years since the advent of electronic toll collection (ETC), key elements are falling in
    Read More
  • eCall mandate: a cost burden for car manufacturers?
    May 14, 2015
    The European Parliament has mandated that all newly approved car and light-van models will have to be equipped with eCall boxes as standard fitment from 31 March 2018. eCall boxes are emergency call devices enabling rescue services to respond with faster road assistance based on knowledge of the exact location of the accident. The 2014 ban on telephone roaming charges across Europe will establish a favourable scenario for an interoperable eCall or telematics solution. However, while the European Commissi
    Read More
  • EU funding kick-starts EETS studies
    February 4, 2014
    The regional European Electronic Toll Services (EETS) initiative is about to be kick-started by over US$3 million of co-financing from the European Union TEN-T Program. A a series of studies aimed at deploying EETS on a cross-border regional scale, selected for funding under the 2012 TEN-T multi-annual programme, specifically cover the electronically tolled primary road network of seven member states: Austria, Denmark, France, Germany, Italy, Poland and Spain, and Switzerland, which receives no EU suppor
    Read More
  • Will standardisation increase ITS interoperability?
    February 1, 2012
    Theoretical balance Kallistratos Dionelis, secretary general of ASECAP, comments on the European Commission's new ICT Standardisation Work Programme. I've just read a proposal from the European Commission on the 2010-2013 ICT Standardisation Work Programme. As ASECAP Secretary General this is one of my responsibilities. I work to receive information, to disseminate information and to build bridges and mutual understanding between policy-makers and the industrial world, between ASECAP and others.
    Read More

Highlighted Content