Skip to main content

Study shows road markings deliver cost-effective road safety

Road markings are among the most cost-effective solutions to make roads safer. A recent study carried out for the American Glass Bead Manufacturer’s Association quantifies by just how much Despite only making up 23% of the US mileage, fatalities on America’s rural two-lane highways made up 57% of all traffic fatalities in 2009 — resulting in more than $77Bn in losses for that year alone. Moreover, a rural motorist is 2.7 times more likely to be involved in a fatal crash per mile travelled than their urban
June 20, 2012 Read time: 4 mins
Jon Sproul, general manager of Swarco Industries

Road markings are among the most cost-effective solutions to make  roads safer. A recent study carried out for the American Glass Bead  Manufacturer’s Association quantifies by just how much

Despite only making up 23% of the US mileage, fatalities on America’s rural two-lane highways made up 57% of all traffic fatalities in 2009 — resulting in more than $77Bn in losses for that year alone. Moreover, a rural motorist is 2.7 times more likely to be involved in a fatal crash per mile travelled than their urban counterpart.

The TTI study, entitled An Evaluation of the Effectiveness of Wider Edge Line Pavement Markings, shows that, just by using six inch (15.25cm) line marking, instead of the still widely used four inch edge line, there is a dramatic improvement in safety and reduction of fatalities on rural two-lane highways.
In its recommendations, the TTI study says, “Agencies can use the results herein to develop a policy for six inch edge lines on their rural, two lane highways. Wider edge lines have been shown to reduce total crashes 15-30%, and fatal plus injury crashes 15-38%.

Comparative Benefit-Cost Ratios by Policy
Wider Edge Lines  
 $32.87-$55.20
 for every $1.00 invested
 Rumble Strips  $37.00-$46.00
 for every $1.00 invested
Chevrons  $8.60-$45.90
 for every $1.00 invested
RRPMs 
 $13.16    
 for every $1.00 invested

The study also looked at other road marking systems and assessed their safety and cost benefits, including rumble strips, chevrons, and raised retroreflective markers

In addition, the benefit-cost ratio for wide edge lines is $33 to $55 for each $1 spent, which is similar to rumble strips. If an agency is considering installing rumble strips as a safety countermeasure but concerned about the potential noise or pushback from the bicycle community, wider edge lines appear to offer similar results but without the concerns often associated with shoulder rumble strips.”

Many states have adopted wider edge lines on a variety of roads for a variety of reasons. The adoption has been slow and uncoordinated, without sound empirical findings to support their policy choice. The recent analysis of data from three states provides the necessary evidence to support the adoption of wider edge lines on rural two-lane highways. Based on the results of the cost benefit analysis above, state DOTs can now have further reassurance that their actions are in the best economic interest of society as well.

Since the safety benefits of wider edge lines are now better documented with rigorous statistical analyses, TTI says it would be beneficial if the MUTCD could be amended so that the minimum edge line width on rural two-lane highways was six inches. Agencies would then be able to implement the policy in a uniform and consistent manner.

Asked to comment on the TTI report, prepared on behalf of the 5963 American Glass Bead Manufacturer’s Association (AGBMA), Jon Sproul, general manager of glass bead and road marking material manufacturer 129 Swarco Industries and a member of the association, said the TTI report is a major contribution towards improving safety on the roads.

“While previous studies always found that edge markings have a positive impact on traffic safety, no reliable statistical data was available to support the hypothesis that wider edge lines further improve traffic safety. The TTI report is based on recent statistically sound data and several surveys conducted over the past decade. The findings confirm that an increase of merely two inches in the width of edge lines will provide better guidance and visibility and hence reduce the number of crashes on rural two-lane highways,” says Sproul and emphasises that road markings still remain among the most cost-effective and reliable solutions to make roads safer.


For more information on companies in this article

Related Content

  • Prowag signals change to vision statement
    February 15, 2024
    New pedestrian signal requirements designed to make crossings safer for the visually impaired mean that accessible signals are no longer just an option for US cities and municipalities. They now have the backing of the law, explains Andrew Stone
  • Printed and flexible electronics in vehicles: major opportunity by 2026
    January 27, 2016
    A new report from IDTechEx Research, Printed and Flexible Electronics in Automotive Applications 2016-2026, indicates that the market for printed and flexible electronics in vehicles is expected to grow to over US$5.5 billion dollars in the next decade, spearheaded by the projected growth of in-mould electronics and OLED technologies. Printed and flexible electronics are beginning to proliferate, with a variety of components and devices coming to market. Several end-user verticals are expected to benefit
  • NOCoE delivers data for diligent DOTs
    April 29, 2015
    David Crawford talks to Dennis Motiani about the role of the new National Operations Centre of Excellence. Consolidating the collective experience of the US transportation system’s management and operations (TSM&O) community, streamlining its information gathering, while cutting research times and costs are the key drivers behind the country’s new National Operations Centre of Excellence (NOCoE). Launched in January at the annual meeting of the Transportation Research Board (TRB), this sets out to be a sin
  • Study shows curve warning systems ‘reduce crashes’
    February 24, 2016
    A study by the US Federal Highway Administration’s Highways for Life has found a small but consistent reductions in mean and 85 percentile speeds on dangerous bends through the use of Tapco’s BlinkerChevron dynamic curve warning and guidance system (DCWGS) instead of static warning signs. The system's detects oncoming vehicles up to 90m (300ft) from the curve and will trigger the flashing LEDs on the signs if the vehicle’s speed exceed a predetermined level to warn the driver of the dangerous curves with e